GE - General Electric PSS25MCNACC Official GE Refrigerator - N Series

User Manual - Page 23

For PSS25MCNACC.

PDF File Manual, 116 pages, Download pdf file

Loading ...
Loading ...
Loading ...
Removingand replacing the doors.
When instafling or moving the refrigerator, the doors may need to be removed in order to fit the refrigerator
through a doorway.
Removing the Doors
Make sure the doors are closed and the refrigerator is
unplugged.
0 Disconnect water line and wiring harness.
Nero tile lower hinge on the fleezer side, push in on tile
collars at each end of tile c()upling, and pull the w;tter
line robing fl'om tile coupling. Also, disconnect _dfing
hmness. Pull tile water line and the harness through the
lower rail.
0 Remove the hinge covers and the hinges.
In order to access the hinges, the hinge covers need to be
rem()ved. Remove the c()ver by grasping it on tile sides,
near the back of the cover, l'ush back on the cover and
lift up at the back, then the fiont.
NOTE: DO NOT use a screwdriver to remove the cover BE CAREFUL
not to break the rear retalbing tab on the hinge cover Removethe
hbges usbg a TorxT-20.
Remove the doors.
Cmetully rotate the door to 90 ? Guiding the dis(onne(ted
water line and _dring harness, lift tile door smdght up.
NOTE: Not li@bg the doorstraight up may damage the bottom hinge.
Place doors on a protectedsurface.
NOTE: Be careful not to pinch the water tubing and the wire harness
at thebottom of the door
NOTE: Do not allow theconnector to contact the floor Hardcontact
can damage theconnector See "Replacingthe Doors."
Replacing the Doors
Place doors on bottom hinges.
With tile door at .0()_h)wer the door maight down onto
the bottom hinge. Cmefillly close the door.
NOTE:Not loweringthedoorstraightdownontothebottomhinge
maydamagethehinge.
NOTE'.Donotallow theconnectortocontactthefloor Hardcontact
candamagetheconnector
Replacetophingesandhingecovers.
Reinstall tile top hinges using a Torx T-20. Replace the
hinge c()vers. If tile doors are not level, a(ljust tile bottom
right hinge with a 7/16" open ended x_aench.
Reconnectwaterline andwiringharness.
Insert water robing back into coupling, making sure the
robing is pushed fro enough into the coupling so that you
no longer see the mark on the robing. Reconnect the
_dfing harness.
Turnonthewater supplyandplug therefrigeratorback in.
Wire Harness%
-- HingeCover
I ' _ Door
_ HingePin
Connector
23
Loading ...
Loading ...
Loading ...