Loading ...
Loading ...
Loading ...
Installingand removingpreviouslyinstalled decoratorpanels.
Read these instructions completely and carefully.
Removing the Handles
In order to remove the decorator panels and replace
with new panels you need to remove the handles.
A T-20 Torxdriver is neede_
O I,oosen and remove the 2 screws in the
Top Trim,
I,oosen and remove tile 2 screws in the bracket
that auaches the Handle to the top of the Door.
Grip the Handle firmly and slide upwards.
The keyhole slots on the Handle slide offthe
buttons on the door.
Open the door and slide out the decot_uor
panels.
TopTrimScrews
BracketScrews
Bracket
Bu_ons
>Slots
Inserting the Door Panels
Before installing the decorator panels, make sure they have been routed out in the proper areas as shown/n the
beginmng of this section. Slide in the panels to perform a toal fit before fastemng down the Handle and Top Trim.
Installing the Handles
Oncethe panels are htted pmperly, install the Handle and Top Trim.
0
@
Slide the keyhole slots on the Handle do_a_
onto the buuons mounted to the til(e of the
door. Slide the Handle downward until the
bracket at the top of the Handle fits flush on
the top of the door.
Replace the two screws in the bracket that
attach the Handle to the top of the Door and
tighten the s_rews to 45 in-lbs torque.
Replace the Top Trim making sure it tits over
the Side Trim and that the locating tabs fit the
inside of the Handle profile.
Replace the Top Trim screws and tighten to
30 in-lbs torque.
22
Loading ...
Loading ...
Loading ...