Loading ...
Loading ...
Loading ...
7
OPERATION OPERATION OPERATION
Clean air of correct air pressure is recommended for the power supply
for this tool. A maximum of 90 PSI at the tool is recommended for most
air tools of this class. Check specications section for recommended
pressure. (Depending on length of air hose and other circumstances, air
pressure at compressor may need to be increased to 100 PSI to ensure
90 PSI at the tool.)
Water in the air hose and compressor tank contributes to reduced per-
formance and damage of the air tool. Drain the air tank and lters before
each use and as necessary to keep the air supply dry.
Hose length over 25’ causes loss in line pressure. Increase hose I.D. or
increase compressor pressure to compensate for the pressure loss. Use
an in-line pressure regulator with gauge if air inlet pressure is critical.
AIR SOURCE
FIG. F
4. Disconnect the Grease Gun from the
Filler Pump (not included).
5. Press the Catch Plate (12) and re-
lease the Plunger Handle (10). Press
the Plunger Handle (10) in as far as
it will go.
Loading ...
Loading ...
Loading ...