Loading ...
Loading ...
Loading ...
11
INSUFFICIENT POWER:
Probable Cause Solution
Dirty or clogged air passages Flush and lubricate tool, drain air tank
and supply line
Insufficient air supply Increase line pressure, make sure
compressor matches tool's air pressure
and consumption needs
Air leakage Use PTFE tape at all fittings and joints.
O-rings Check tool for worn or damaged seals.
Air pockets Press in The Air Vent Valve (10) at the
same time pull back and fully extend
the Plunger Handle (19) several times.
Then push the Plunger Handle (19) all
the way in and tighten the Container
Tube (17) to the Gun.
Worn/damaged wear &
tear parts Replace as necessary.
Tool matching Be sure you are using a tool suited for
the lubing requirements of the
job at hand.
TROUBLESHOOTING
Loading ...