Loading ...
Loading ...
Loading ...
General cleaning will help prolong the life and performance of your treadmill. Keep the unit clean
and maintained by dusting the components on a regular basis. Clean both sides of the Running
Belt (No. 25) to prevent dust from accumulating underneath. Keep your running shoes clean so
that dirt from your shoes does not wear out the Running Board (No. 24) and Running Belt (No.
25). Clean the surface of the Running Belt (No. 25) with a clean, damp cloth. Keep liquids away
from electrical parts and Running Belt (No. 25).
To better maintain the treadmill and prolong its life, it is suggested that the treadmill be powered off
for 10 minutes every 2 hours and fully powered off whenever not in use.
Adjusting Running Belt Centering and Tightness:
a. If the Running Belt (No. 25) doesn’t stop when you press it, the Running Belt (No. 25) and
motor belt is positioned correctly.
b. If the Running Belt (No. 25) stops when you press it, but the motor belt and the front roller don’t
stop, the Running Belt (No. 25) is loose. Adjust the Running Belt (No. 25) for safe use.
c. If the Running Belt (No. 25) and motor belt stop when pressing the Running Belt (No. 25) and
the motor still runs, the motor belt needs to be adjusted for the safe use.
It is necessary to adjust the Running Belt (No. 25) with Allen Wrench (No. 20) to the best
condition for the better use of the treadmill.
1. Put the motorized treadmill on level ground. Let the treadmill run at the speed of 6-8 MI/H,
observe the Running Belt (No. 25) deviating condition.
2. If the Running Belt (No. 25) deviates to the right, pull off the Safety Key (No. 128) and unplug
the power. Turn the right side adjusting bolt clockwise by 1/4 circle. Turn on the treadmill and
watch the Running Belt (No. 25) to see if it is centered. Repeat the above steps, until the
Running Belt (No. 25) is in the middle. Please refer to figure A.
3. If the Running Belt (No. 25) deviates to the left, pull off the Safety Key (No. 128), unplug the
power, turn the left adjusting bolt clockwise by 1/4 circle. Turn on the treadmill and watch the
Running Belt (No. 25) to see if it is centered. Repeat the above steps, until the Running Belt
(No. 25) goes to the middle. Please refer to figure B.
4. After the above adjustment or after multiple uses, Running Belt (No. 25) may become loose and
needs adjustments. Pull off the Safety Key (No. 128), turn off the power switch, and turn the left
and right adjusting bolts clockwise by 1/4 circle. Turn on the treadmill, then stand on the treadmill
to confirm the tightness of the Running Belt (No. 25). Repeat above steps, until the Running
Belt (No. 25) is moderate in tightness. Please refer to figure C.
Maintenance Guidelines
Version 1.8
Fig:B
Fig:C
Fig:A