Loading ...
Loading ...
Loading ...
31
TROUBLESHOOTING
Operating problems
PROBLEM POSSIBLE CAUSES WHAT TO DO
Too much or too little
water when filling
Machine has been set to a Manual
Water level rather than Auto.
Your washer has been designed
to automatically sense load size
and minimise water use, therefore
the water level may look different
to your previous washer.
Ensure Auto Water Level is set rather than
setting the water level yourself.
Wash water
temperature is
not warm
The unique high efficiency was
system uses 2 wash phases on
the COTTON, ECO, HIGH, FAST
cycle. The second phase will be
cooler than the first to minimise
energy use.
This is normal and will not affect
wash performance.
If ECO is selected the wash
temperature will be cooler to
save energy during the wash
cycle.
Too many soap suds Incorrect detergent being used. Ensure you are using a Low Suds detergent.
Try using a little less detergent, especially if
garments are only lightly soiled.
Your washer is
making noises
Load is out of balance.
Press
and redistribute the load.
There is a fault indicated by
continuous beeping or a series
of beeps.
Refer to ‘Fault codes’.
Small puddle
coming from under
the washer
A dispenser may be blocked. Refer to ‘Care and Cleaning’.
Cover at the inside
rear of washer,
between the two
dispensers, does not
open.
Model WL1064G1 has a non-
functional cover located between
the two dispensers, which is not
designed to be opened.
Do not try to open the cover. Damage will
result.
Loading ...
Loading ...
Loading ...