Loading ...
Loading ...
Loading ...
24
I. Startup
WARNING
All parts are factory-adjusted. Improper adjustments may adversely affect safety,
performance, component life, and warranty coverage.
NOTICE
• If the appliance is turned off, wait for at least 3 minutes before restarting the
appliance to prevent damage to the compressor.
• To prevent damage to the water pump, do not leave the control switch in the
"WASH" position when the water tank is empty.
• At startup, conrm that all internal and external connections are free of leaks.
• The remote condensing unit must have power for a minimum of 4 hours prior to
startup to prevent compressor damage.
1) Open the water supply line shut-off valve.
2) Remove the front panel.
3) Move the control switch to the "ICE" position.
4) Replace the front panel in its correct position.
5) Turn on the power supply, and allow the icemaker to operate for a total of 10 minutes.
6) Turn off the power supply, then remove the front panel. Move the control switch to the
"OFF" position.
7) Remove the top and left side panels, then remove the insulation panel.
8) Disconnect the distributor from the distribution hose. Remove the thumbscrew securing
cube guide B. Remove cube guide B and cube guide A. See Fig. 13.
Fig. 13
Cube Guide A
Distribution
Hose
Cube Guide B
Thumbscrew
Drain Plug
Overow Cap
Overow Pipe
Insulation Panel
Front Panel
Ice Storage
Bin
Top Panel
Cleaning
Valve
Left Side Panel
Distributor
Loading ...
Loading ...
Loading ...