Loading ...
Loading ...
4 BISSELL.com BISSELL.com 5
Before cleaning, vacuum to remove loose dirt from area. Spray any BISSELL® stain pretreat formula to
soiled areas and allow to sit for a few minutes.
1. Release the hose by twisting
the secure latch. Choose your
tool and snap on the end of
the hose.
2. Twist the Quick Release™
Cord Wrap and unwind the
cord to plug into outlet.
3. Press the power button to
turn ON (|) and OFF (0).
WARNING When using the Deep Stain Tool, always keep the tool in direct contact with carpeting to avoid
over-spraying. Keep spray away from face. Failure to do so may result in personal injury.
Getting Ready to Clean
Using the Tools
Tools vary by model. Visit BISSELL.com to purchase additional tools.
CONTINUED ON NEXT PAGE
Tough Stain Tool, 15cm Tool, and Crevice Tool
1. Point tool above spot or stain and press
spray trigger.
2. Release spray trigger and gently scrub
the stain.
3-in-1 Stair Tool
a
b
c
1. Twist tool to desired
position. The downward facing
edge is the active cleaning
mode.
2. Use to clean stairs three
ways:
a. Flat edge: stair tread
b. Indented area: outer corner
c. Pointed edge: inner corner
3. Point the tool about 1 inch
above the stain and press the
spray trigger. Suction the stain
by placing tool onto surface
and slowly moving backwards.
Deep Stain Tool
1. Set the tool directly on to the carpet and pull
the trigger.
2. Scrub back and forth to suction away the
spot or stain.
HydroRinse™ Self-Cleaning Hose Tool
1. Hold the hose and tool in an upright position
with the machine ON. Hold down the trigger for
30 seconds. Be sure to empty the dirty water
tank after use (next page).
2. You can store tool on machine, as shown.
Using the Tools (continued)
Loading ...
Loading ...