Loading ...
Loading ...
Loading ...
A utomatic Ice and Water Dispenser
PureSource2 TM * Ice and Water Front Filter (some models)
NOTE: Ifyou purchased a refrigerator with a PureSource2T_°lce and Waterfront filter, please read the followinguse
and care information. Th_stceand water filter system filters watertoyour icemaker and water dtspenser Itislocatedm
theupperrightfront cornerofthefresh food compartment
System Startup:
Water supply does not needto be turnedoff, however, do notuseiceand water dispenser while instalhngfilter
The filter cartridge has already been tnstalledin the filter housingat the factory. Refer to the How The Water Dmpenser
Works section to properly fill the system with water.
Changing the Filter:
Filter Water cond=t]onsvary throughout the world,butchanging the waterfilter every
6 - 9 months normally will ensure the highest possible water quahty.The Filter
Status hghtwillturn red after approximately 400 gallons of water has flowed
through the ice and water dispenser.Also, _fthe filter has been in a refngerator
ti thathas notbeen inuseforawhile (dunng movingfor example),changethe fdter
beforere_nstalhngtherefngerator Thed_spensersystemwillalsooperatewtthout
filtretlon (with filtercartndge removed andbypass installed)
PushIn
andClick
TOInstall ToRelease
Order new fdter cartridges through the
dealer where you bought the refrigerator,
or contact the Consumer Asststance
Center at 1-800-944-9044 It might be
good to order some filter cartndges when
you first install your refrigerator Be sure
to ask for the PureSource2 TM *
replacement cartndge
F_ The PureSource2 r_"Ice and
(NSF. Water F,lter System NGFC2000 with the PureSource2 r_"
cartridge FC 100 tstestedand
certified by NSF International,
the nationally recognrzed and respected,
not for profit, certification orgamzatJon for
public health safety The PureSource2 n"
Fdtersystem _stested and certified to ANSI/
NSF Standards 42 and 53. See
performance data sheet forspectticattons
Thts system should not be used on water
that _smicroblolog_cally unsafe or with water
of unknown quahty unless the water has
been adequately disinfected before or after
travehng through the filtration system.
• Rated Capactty- 400 gallons
• Rated service flow - 5 GPM
•Maxtmum Rated Pressure - 100 PSi
• Maximum Operating Temp - 100 ° F
To change filter:
itis not necessary to turn the watersupply off tochange the filter
1. Set_cemaker wire signal armto the OFF (up)position (See illustration on
page 13).
2. Push the Fflter Release Button, located to the nght ofthe filter cartndge,
to release the filter from the housing. To mmtm_zethe possibll_tyofthe
fdterfalhng out of the housing dunng removal, _twould bebest to hold the
fdter as =tmoves outtoward you.
NOTE. A smallamount of water may be released during thisoperation.
You should have a paper towel or dish clothhandyto wipe up any water
that may drip out of the filter or housing. Two small holes near the back of
the hous}ng have been added for any excesswater to escape. Itwouldbe
best to clear away anyfood near this area on the top shelf in advanceof
removing thefilter.
3. Pull the oldfiltercartndge straight out of the housing.
4, Discard the old filter
5. Remove the new filter cartridge from the packaging and _nsertintothe
_ter housing the same way the otd one came out
6 Whenthe cartndge isalmost in,you willfeel =tstopagainst thecltpassembly
in the back of the housing. The clip assembly holds the filter cartridge
firmly in place.At this point, you will need topush firmly until the cartndge
snaps fully_nplace.When completely tnplace,the front ofthefiltercartndge
will be flush with the front of the housing
7. Set the _cemaker wire signal arm to the ON (down) posit_on
8. Fill a glass with water. As you are doing this, check for leaks at the filter
housing There willbe not_cablespurtsand sputters asthe system pushes
the air outthrough the systemand out thed_spensernozzle This isnormal.
9 After you have run one glass of water, continue to flush the system for
approximately 3 minutes toassure that the purestwater possible isstored
Inthe water storage tank.
IMPORTANT: Resetting The Filter Status Light (some models)
After replacing thefiltercartridge,it willbe necessary to press the Filter
Resetbutton located on the ice and water dispenser. This wtll reset the
Filter Status hght.Push the reset button until the green, red and amber
lights flash (10-15 seconds). Please refer to the complete dtspenser
operattng instructtons attached to thereside ofthe freezer door.
* White Westinghouse uses the name CnjstalClear instead of PureSource, but they are the same filter
16
Loading ...
Loading ...
Loading ...