Loading ...
Loading ...
Loading ...
Automatic Ice and Water Dispenser
PureSource TM*Ice and Water Filter (some models)
NOTE: Ifyou purchased a refrigeratorwith a PureSource n.. ice and Water filter, please read the followinguse and
careinformation. Thisiceand water bitersystem filters water to your ice maker and waterdispenser It islocated inthe
upper right back corner of the fresh food compartment
System Startup:
Water supply does not need to be turned off, however, do not use ice and water dtspenser while installing filter. The filter
cartndge has already been installed in the filter housing at the factory Refer to the How The Water Dispenser Works sect=on
to properly fill the system with water Changing the Filter:
Water cond=bons vary throughout the world, but changing the water filter every
6 - 9 months normally will ensure the h=ghest poss=b]e water quality The Filter
Status hghtwdl turn red after 400 gallons of water has flowed through the ice and
J water dispenser (some models) Also, _fthe filter has been in a refngerator that
has not been m use for awhile (during moving for example), change the filter
_. FilterHouslog_
SmallO-dng-J_
FtlterCadndgs-r_-J
LargeO-dng-J_--T_
FilterCupJ_
Twistto Remove
Order new filter cartndges through the
dealer where you bought the refrJgerator,
or contact the Consumer Assistance
Center at 1-800-944-9044 It m=ghtbe
good to order some tilter cadndges when
you first install your refngerator Be sure
to ask for the RG-100 PureSource _*
replacement cartndge
"_" The PureSource TM * NGRG-
NSE 2000 Ice and Water Filter
') System w=th the RG-t00
'_. / cartridge _s tested and
certihed by NSF International,
the nationally recogmzed and respected,
not for profit, certification organization for
_ubhc health safety The PureSouree rM*
system ts tested and certified to ANSI/NSF
Standard 42 See performance data sheet
for specrilcatJons Thts system should not
be used on water that is mlcroblologlcally
unsafe or w_th water of unknown quahty
unless the water has been adequately
disinfected before or after traveling through
the filtration system
before reinstalling the refrigerator The dtspenser system w_llalso operate without
filtration (with filter cartndge removed)
To change filter:
It =snot necessary to turn the water supply off to change the filter
1 Open freezer door and leave open until filter change is complete
2 Set tce maker wire signal arm to the OFF (up) position (See dlustrat_onon
page 13)
3. Hold filter cup firmly, and unscrew towards left (Some water could
leak out as you remove cup Thts ts normal.) Filter cartedge should come
down with cup If cartndge remains in housing, pull down gently, while
twisting filter back and forth
4 Rinse out cup under running water
5 The large o-nog that seals the filter system sets Jnthe o-nng groove
down reside the cup Should the o-nng fall out during filter cartndge
replacement, s_mply place tt back in the groove pcer to screwing the cup
back tn place If the o-nng becomes damaged, you will need to order one
from the Consumer Assistance Center
6. Discard old filter cartndge
7. Remove new filter cartndge from packaging and place in cup. The end
with the small o-nng should be up, out of the cup.
8. Screw cup, with hirer,back onto housing Do Not Use Wrench To Reinstall
Cup Filter cartndge wdl self-ahgn as cup is ttghtened. Be sure cup is
completely tightened w_th PureSource TM logo facmg outward Do Not
Tighten Past Stop.
g Set ice maker wire signal arm to the ON (down) position
t0 Check for leaks Open refrigerator door. Wtpe any water droplets from the
ftlter cup Fdl a glass with water If there _sa leak, unscrew filter cup, and
remsert the filter cartridge Check placement of large O-ring Reinstall
filter cup, makJng sertam _tts t_ghtened completely.
t 1. To conddlon filter system and purge air from water hoe, hll a glass with
water Continue flushing the system for apprexlmately 3 m_nutes to assure
that the purest water possible _sstored tn the water tank
Rated Capacity - 400 gallons
• Rated servtce flow - 5 GPM
• Maximum Rated Pressure - 100 PSI
• Maximum Operahng Temp - 100 ° F
IMPORTANT: Resetting The Filter Status Light (some models)
After replacing the filter cartndge, it wrll be necessary to press the Filter
Status reset button located on the tce and water d=spenser.This will reset
the Filter Status hght Push the reset button until the green, red and amber
lights flash (10-15 seconds). Please refer to the complete dispenser
operating instructions attached to the inside of the freezer door
On models without a Filter Status reset button, there is a set of
Reminder Stickers tncteded m the envelope that the Use & Care Manual
came m. Choose a dated sbcker that indicates 6 - 9 months (depending
on your water quahty and usage) from the date of installation. Place the
sbeker on the front of the filter cup to remind you when d _s time to
change the filter.
• Whtte Westinghouse uses the name CrystalClear instead of PureSource, but they are the same fdter
15
Loading ...
Loading ...
Loading ...