Loading ...
Loading ...
Loading ...
ENGLISH 17
Installation
Attach Dacor badge
Use the template on this page for alignment of the badge.
Cut out the template and tape it onto the hood front
surface and verify the template is aligned with the right
side of the hood and within the upper and lower edge of
the front surface. Practice placing the badge rst before
removing the adhesive release paper.
Strip LED
Controls
Badge
Te
mplate
NOTE: The nameplate badge has very high retention adhesive - once the nameplate
badge is attached its extremely difÞcult to remove.
Before removing the release paper from the back of the nameplate badge, practice
placing the nameplate badge in the proper position on the hood without any
overlap between the nameplate badge and this template.
After this practice, remove the release pper from the back of the nameplate badge,
and attach the nameplate badge to the hood without any overlap of the nameplate
badge to this template.
Remove and discard this template.
Lower view of the edge of the hood
Loading ...
Loading ...
Loading ...