Loading ...
Loading ...
Loading ...
ENGLISH14
1. Determine and make all necessary cuts in the wall
or roof for the vent system. Install the vent system
before installing the cabinet hood insert. See the
“Venting Requirements” section.
2. Determine the location where the power supply cable
will be run through the wall.
3. Drill a 1¼” (3.2 cm) hole at this location.
4. Pull enough power supply cable through the wall to
allow for easy connection to the terminal box.
5. Remove terminal box cover (A) and set aside.
30" Single fan models
A
36" and 48" Double fan models
A
6. Remove knockout from the top of the vent hood and
install a UL listed or CSA approved ½” (1.3 cm) strain
relief.
7. Place the hood insert near its mounting position and
run the power supply cable through the strain relief
into terminal box (enough to make connection).
8. Tighten the strain relief.
9. Using 2 or more people, lift the hood insert into hood
cabinet.
10. Fasten the hood using 4 - 5 x 45 mm screws with
washers to the hood cabinet and tighten securely.
WARNING
EXCESSIVE WEIGHT HAZARD
USE TWO OR MORE PEOPLE TO MOVE AND INSTALL
HOOD INSERT.
FAILURE TO DO SO CAN RESULT IN BACK OR OTHER
INJURY.
4 - 5 x 45mm
screws with washers
Upper hood
Insert motor housing
Installation
Loading ...
Loading ...
Loading ...