Broan B5736SS Convertible Arched Canopy Wall-Mount Chimney Range Hood

Installation Instructions - Page 5

For B5736SS. Also, The document are for others Broan models: B5630SS, B5636SS, B5730SS

PDF File Manual, 28 pages, Read Online | Download pdf file

B5736SS photo
Loading ...
Loading ...
Loading ...
SR - N
MODELS B5630SS ,, B5636SS ,, B5730SS ,, B5736SS
Page 5
6" ROUND
ELBOW
I I
I I
I I
10. Measure and install 6" round steel ductwork to roof cap or
wall cap and 900 elbow over duct collar on hood. Use duct
tape to make all joints secure and air tight.
11. Plug hood power cord into the outlet.
LOWER
FLUE
LOWER FLUE MOUNTING BRACKET
NOTE: 10-ft. ceilings require 10-ft. Flue Extension, Model
FXN56SS for ducted or non=ducted installations (purchase
separately). Discard the upper flue supplied with your hood
and replace it with the Model FXN56SS flue extension.
12. Remove the upper flue from inside the lower flue. Install the
lower flue bracket to the lower flue using (2) flue bracket
screws no. 8 x 3/8'.' Make sure that the slots are at the top.
Carefully replace the upper flue inside the lower flue. Remove
protective plastic film covering the lower flue only.
13. Carefully place both flues into the recessed area of hood top.
14. Slide the upper flue upward until it is aligned with its upper
UPPER FLUE MOUNTING BRACKET
FRONT VIEW
...... ......
UPPER
FLUE
15.
16.
flue mounting bracket. The bracket should be inside the flue.
Secure the upper flue to the upper flue mounting bracket
using (2) no. 8 x 3/8" mounting screws.
Remove protective plastic film covering the upper flue and
the hood.
Mount the glass plate or the stainless steel plate on the top
of hood base with (4) flat head screws (M4 x 1.0") and (4)
decorative washers. Screw from top of hood base. Do not
overtighten these screws.
INSTALL THE HOOD
(Vertically Ducted Hoods Only)
1.
2.
3.
4.
5.
DO NOT REMOVE the protective plastic film covering the
decorative flue and the hood at this time.
Lay the back side of the hood flat on a table. Use a piece of
cardboard to avoid damaging the table or the hood.
Attach damper / duct connector to top of hood using (4)
#8 x 3/8" Pan Head mounting screws.
Remove the grease filters by pulling down the metal latch
tab and tilting filters downward to remove.
Carefully rotate hood upright.
LOWER FLUE MOUNTING BRACKET
"U" "U"
LOWER
FLUE
NOTE: 10-ft. ceilings require 10-ft. Flue Extension Model
FXN56SS (purchase separately). Discard the upper flue
supplied with your hood and replace it with the Model
FXN56SS flue extension.
6. Remove the upper flue from inside the lower flue. Install the
lower flue bracket to the lower flue using (2) flue bracket
screws #8 x 3/8", make sure that the slots are at the top.
Carefully replace the upper flue inside the lower flue.
Remove protective plastic film covering the lower flue only.
7. Carefully place both flues into the recessed area of hood top.
Loading ...
Loading ...
Loading ...