Loading ...
Loading ...
Loading ...
STARTING AND OPERATING 197
Lane Crossed (Flashing Yellow Lane Line) With Flashing
Yellow Telltale
NOTE:
The LaneSense system operates with similar
be
havior for a right lane departure.
CHANGING LANESENSE STATUS
The LaneSense system has settings to adjust the
intensity of the torque warning and the warning
zone sensitivity (Early/Medium/Late) that you can
configure through the Uconnect system
Ú page 229.
NOTE:
When enabled the system operates above
37
mph (60 km/h) and below 112 mph
(
1
80 km/h).
Use of the turn signal suppresses the warnings.
The system will not apply torque to the steering
wheel whenever a safety system engages
(Anti-Lock Brakes, Traction Control System,
Electronic Stability Control, Forward Collision
Warning, etc.).
PARKVIEW REAR BACK UP CAMERA
The ParkView Rear Back Up Camera allows you to
see an on-screen image of the rear surroundings of
your vehicle whenever the gear selector is put into
REVERSE. The image will be displayed on the
Uconnect display screen along with a caution note
to “Check Entire Surroundings” across the top of
the screen. After five seconds this note will
disappear. The ParkView Camera is located in the
center of the tailgate handle.
NOTE:
Removing the tailgate will disable the rearview
ca
mera function.
Manual Activation Of The Rear View
Camera
1. P
ress the Controls button located on the
bottom of the Uconnect display.
2. Press the Back Up Camera icon to turn the
Rear View Camera system on.
When the vehicle is shifted out of REVERSE with
Ca
mera delay turned off, the rear Camera mode is
exited and the previous screen appears again.
When the vehicle is shifted out of REVERSE with
Ca
mera delay turned on, the rear Camera image
will be displayed for up to 10 seconds after shifting
to another gear, unless the vehicle speed exceeds
8
mph (13 km/h), the transmission is shifted into
PARK, the ignition is placed in the OFF position, or
the touchscreen X button to disable display of the
Rear View Camera image is pressed.
Whenever the Rear View Camera image is
activated through the Back Up Camera button in
the Controls menu, and the vehicle speed is
greater than, or equal to, 8
mph (13 km/h), a
di
splay timer for the image is initiated. The image
will continue to be displayed until the display timer
exceeds 10 seconds.
NOTE:
If the vehicle speed remains below 8 mph
(13 km/h), the Rear View Camera image will be
di
splayed continuously until deactivated via the
touchscreen X button, the transmission is
shifted into PARK, or the ignition is placed in the
OFF position.
The touchscreen X button to disable display of
the camera image is made available ONLY when
the vehicle is not in REVERSE.
4
Loading ...
Loading ...
Loading ...