Loading ...
Loading ...
Loading ...
20
Trouble Shooting
Problem Cause Remedy
Saw will not start. 1. The battery is not
properly connected, or
its charge is depleted
1. Reattach battery; charge
battery, if needed.
2. Burned out switch. 2. Have switch replaced by an
Authorized SKILSAW Service
Center or Service Station.
3. Trigger does not turn
tool on.
3. Have switch replaced by an
Authorized SKILSAW Service
Center or Service Station.
Excessive vibration. 1. Blade out of balance. 1. Discard blade and use a
different blade.
2. Workpiece not
clamped or supported
properly.
2. Clamp or support workpiece
properly according to this
manual.
Cannot make square cut
when crosscutting.
1. Foot not be adjusted
properly.
1. See “Operating Instructions”
section, “Bevel Adjustment”,
“Line Guide”, “Cutting Large
Sheets and “Rip Cuts”.
Cut binds, burns, or stalls
motor when ripping.
1. Dull blade with
improper tooth set.
1. Discard blade and use a
different blade.
2. Warped board. 2. Make sure concave or hollow
side is facing “DOWN” feed
slowly.
3. Blade binds. 3. Assemble blade and tighten
Vari-Torque clutch per
“Assembly Instructions”.
4. Improper workpiece
support.
4. Clamp or support workpiece
properly according to this
manual.
Blade slipping. 1. Tool does not cut
workpiece.
1. Reassemble the blade
and tighten the washers
according to this manual.
Loading ...
Loading ...
Loading ...