Loading ...
Loading ...
Loading ...
IF THE BELT IS RUNNING TO THE RIGHT OF CENTER:
1. Start up the running belt at a constant speed of 1.5 mi/hr.
2. Use the provided hex key to turn the right adjustment screw, located at
the back end of the treadmill, ¼ turn clockwise.
3. Let the treadmill run at a constant speed of 1.5 mi/hr for about
2 minutes.
4. If the running belt is now running in the center of the running deck, the
adjustment was successful. If the belt is still off-center, repeat steps
1–3 until the belt is running in the center.
NOTE: If the belt cannot be adjusted, please contact a support
representative immediately.
RE-TENSIONING THE RUNNING BELT
If the running belt begins to jolt or skid noticeably during operation, the
belt is too loose and must be re-tensioned. The running belt is re-tensioned
using the same adjustment screws used when adjusting the belt, located at
the back end of the treadmill.
1. Start up the running belt and let it run at a constant speed of 1.5 mi/hr.
2. Use the provided hex key to turn one adjustment screw, then the other,
½ turn clockwise.
3. Alternately, if the belt is too tight, you will feel excessive resistance or
pausing. In this case, use the provided hex key to turn one adjustment
screw, then the other, ½ turn counterclockwise.
Endurance Training Collection 29
MAINTENANCE AND CARE
ADJUSTING THE RUNNING BELT
To assure the longest service life possible, the running belt should always
be kept running straight along the center of the running deck. Therefore, it
is important to examine the belt before each training session to see if it is
straight and running in the center of the deck or if it has changed position.
Possible reasons for the running belt changing position are:
• The ground on which the treadmill is standing is either uneven or at an
incline.
• Personal running style (for example, distribution of weight to one side,
in- or out-turned feet).
NOTE: If the running belt has become so displaced that it is rubbing along
one of the foot rails, this will cause friction and damage the running belt.
Damage caused by failure to make adjustments to the belt or insufficient
adjustments will not be covered by the warranty.
HOW TO ADJUST THE RUNNING BELT
IF THE BELT IS RUNNING TO THE LEFT OF CENTER:
1. Start up the running belt at a constant speed of 1.5 mi/hr.
2. Use the provided hex key to turn
the left adjustment screw, located
at the back end of the treadmill,
¼ turn clockwise.
3. Let the treadmill run at a constant
speed of 1.5 mi/hr for about
2 minutes.
4. If the running belt is now running
in the center of the running deck,
the adjustment was successful. If
the belt is still off-center, repeat
steps 1–3 until the belt is running
in the center.
28 PacerMini Pro User Manual Lifepro
Loading ...
Loading ...
Loading ...