Loading ...
Loading ...
Loading ...
II / Assembly
C.
Connecting the Casters - Lift the unit carefully with a forklift using the built in fork
pockets; DO NOT TILT the unit to bolt the casters to the base. Use all bolts and nuts
included, 4 for each caster and tighten well.
Install Flanges - All flanges are pre-drilled and measured to fit on your KPO. Line up
the holes in the flanges to the threaded female insert on the cabinet and install included
fasteners, tighten well. Loose flanges will leak air and can diminish performance.
Installation Site - Preview your installation site, DO NOT place the KPO in the space
that you are cooling. Your KPO is designed to be placed outside the conditioned space
and ducted in. Before moving your KPO into place verity the following. The direction you
would like the supply and return air to go (cooling), the direction you would like the hot air
exhaust to go (heat removal), where will the condenser make-up air coming form, where
is your power supply located and where is the condensate water pumping too? Position
the unit based on these guidelines for best results. NOTE: Leave at least 5’ of space
open around the make-up air inlets for the condenser to ensure proper operation.
A.
B.
III / Power Connections
Verify the source power, phase and breaker size is compatible with the units serial plate
information, if you are not sure contact a licensed electrician. The KPO 5-ton comes from
the factory with an 8’ power cable sized to fit the electrical specifications of the units’
electrical requirement and has no male receptacle attached. The KPO 12-ton comes without
a power cable and has 4 male cam lock connectors ready to receive the corresponding
female cam locks, the female cam locks, or complete cord line set can be purchased
separately with the proper cable size attached from the factory in various lengths. Users of
208/320 volt units will be required to set a switch located in the units’ control compartment
to select incoming voltage: the default selection from the factory is 208 volt. 230 volt
requires the switch to be changed.
IV / Operational Safeguards
Read the following safeguards carefully before installing your KPO KwiKool:
C.
Do not operate or install your KwiKool unit in a potentially explosive, combustible, or
corrosive gas atmosphere.
Keep your KwiKool system away from flammable materials and open flame.
To avoid electrical shock keep your KwiKool system away from direct contacts with water
and any liquids. Do not touch your system with wet hands.
To insure your KwiKool system is stable, the ground on which the system is to be placed
should be level, free of vibration and strong enough to support the weight of your
KwiKool model.
Do not move the system while it is operating. Before moving the system, first turn to
OFF then unplug the system from the power source. Then unlock the casters.
A.
B.
E.
D.
Page 5
Loading ...
Loading ...
Loading ...