Loading ...
Loading ...
Loading ...
IX / Phase Monitor - Troubleshooting
Page 17
PROBLEM
LCD
Readout CORRECTIVE ACTION
Load will not
energize
Load will not
energize
Fault LED blinks
repeatedly while
load is energized
Load will not
de-energize
when control
voltage is OFF
Setup LED is on
while load is
being energized
Load will not
energize
Load turns ON
and OFF
repeatedly
Phase
Avgerage
LCD
Status
Phase
Avgerage
Phase
Avgerage
Phase
Avgerage
Anything
other than
Phase
Avgerage
Reset
Readout is
Irrelevant
All LEDs Off
Load LED Off,
Fault LED
Blinking
Fault LED
Blinking,
Load LED On
Load LED On,
Control LED Off
Setup LED on,
Load LED On
Fault LED
Blinking
Fault LED
Blinking
Confirm that the control input (terminals 1 & 3) is
properly connected and configured
Press FAULT once to observe the current fault;
correct the condition of the first fault that appears
(see FAULT Conditions, for a list of corrective
actions)
Indicates there are faults saved in the memory,
press FAULT rapidly to scroll through saved faults;
to clear the faults, press and hold FAULT for more
than 5 seconds
To exit the setup mode, press either READ
or FAULT
Unit in lockout; maximum number or retries in
manual reset mode has been reached; to reset
unit, press FAULT and hold for more than 5
seconds
The control mode setting is OFF; press SETUP
to get the control mode.
Press to set the control mode ON
Fix load side fault; press FAULT to observe
condition; the delay on break period may be too
short; press SETUP to enter the delay on
break mode;
press to lengthen the delay
Loading ...