Loading ...
Loading ...
Loading ...
STARTING
If the trimmer is to be used for the first time, check that the nylon line
touches or passes over the cutting blade. The nylon line will be cut
automatically when turn on the switch to the maximum length. If it
does not reach the necessary length, push the head of spool with your
finger while pulling the lines.
Insert the plug into the extension cable and attach it to the handle.
Pressure the switch and make the trimmer turn at no load; thus, the
line length is automatically adjusted. Only approach the implement
to the grass to be cut while it is in operation, i.e. while the switch is
pressed down.
CAUTION: Before turn on the switch, take the blade cover away.
To cut long grass, take several small cuts. Never cut wet or very damp
grass. The line has to be protected against premature wear caused by
hard obstacles; for this purpose, keep the trimmer away from hard
surfaces using the guard’s edge as a protection. A short or worn line
will reduce cutting capacity. So, to restore the line to its optimum
length, push the implement to the ground while it is running; this way,
the line will automatically be the correct length.
CAUTION: The short or worn line cuts less efficiently therefore, to
improve its operations, unplug the electrical supply and repeat the
operation described in the beginning of the chapter. These make sure
that everything is functioning properly and to familiarize yourself with
the grass trimmer.
CAUTION: After switching off, the nylon line will continue to rotate for
a few more seconds.
GENERAL CUTTING TIPS
When cutting, ensure of a firm footing to allow for more effective
cutting & a proper discharge of the clippings. We recommend that you
cut longer grass in stages. Start at a higher cutting height & go over
the same area a second time with a lower cutting height.
DO NOT: Cut wet grass; it will stick to the blade/cutting line &
deck/guard, preventing proper discharge of trimmings.
USE OF THE CABLE HOLDER
The handle is equipped with a cable holder that serves for connection
of the extension cable.
.
9
Loading ...
Loading ...
Loading ...