Loading ...
Loading ...
Loading ...
• After striking a foreign object. Inspect the appliance for damage
and make repairs as necessary.
• If the appliance starts to vibrate abnormally, check immediately.
• When the machine is at work in the thick bushes or runs into
obstacles it can’t cut down, the blade will be stalled so that
the machine temperature and current will increase. When the
temperature is too high or the current is too large, the overload
protection device installed inside the machine will automatical-
ly shut off the power to stop the machine (main purpose is to
protect motor and prolong motor life). At this moment, let go of
the trigger and disconnect power supply of the machine, let the
machine cool in some time (1~2 mins) and then restart switch,
the machine can rework.
WARNING
Like all machinery there is potential danger when operating this
machine. Accidents are frequently caused by lack of familiarity
or failure to pay attention. Use this machine with respect and
caution to lessen the possibility of operator injury. If normal safety
precautions are overlooked or ignored, serious personal injury
may occur.
CAUTION
No list of safety guidelines can be complete. Every environment
is different. Always consider safety first, as it applies to your
individual working conditions. Use this and other machinery
with caution and respect. Failure to do so could result in serious
personal injury, damage to equipment, or poor work results.
ELECTRICAL SAFETY INFORMATION
WARNING
• IMPORTANT: Make sure that the electric circuit is fused, and
that the power, voltage and frequency of the motor is supported
by your mains supply. Also, make sure, that your power supply is
earthed. Connect your power tool to earth. Never open the ON/
OFF switchbox. However, if it should become necessary to do
so, contact a qualified electrician. Make sure that you will never
touch live contacts, specifically when you plug or unplug your
log splitter. This machine and its power cord must never get into
contact with water.
• Never use its power cord to move/shift your power tool. Always
unplug the power cord before handling your power tool. Do not
yank the plug out of the wall socket by the cable and protect the
latter against heat sources, oil and objects which can damage it.
Neither expose your power tool to rain and wetness.
• NOTE: When equipment like this is being started a short-time
voltage drop may occur, particularly if the mains quality is poor.
Such drops can affect other consumers (e. g. flickering of a
lamp). At a mains impedance of Zmax < 0.448 Ω, such trouble is
not to be expected.
ELECTRICAL CONNECTION
• The single-phase 230 V/50 Hz motor of this lawnmower should
be connected to a standard 230 V + 10 %/50 Hz + 1 Hz power
supply source provided with a residual-current circuit breaker.
• CAUTION: Any unprofessional use of extension cables can
cause overheating to this lawnmower. Ensure that the extension
cable is not longer than 10 m and its wire cross section is not
less than 2.5 mm². Never use uninsulated or bare cables,
respectively. The extension cable must be suitable for outdoor
use.
7
Loading ...
Loading ...
Loading ...