Loading ...
Loading ...
Loading ...
NOTE
This drill has an electric brake. Release the switch trigger to
stop the chuck from turning. When the brake is working
correctly, sparks can be seen through the exhaust slots on
the housing. This is normal and is the action of the brake.
4.7 DRILL MATERIALS
WOOD DRILLING
For maximum performance, use high speed steel bits for
wood drilling.
1. Operate the machine at a very low speed to prevent the
bit from slipping off the starting point. Increase the speed
as the drill bit bites into the material.
2. When drilling through holes, put a piece of wood behind
the workpiece to prevent ragged or splintered edges on
the rear side of the hole.
METAL DRILLING
For maximum performance, use high speed steel bits for
metal or steel drilling.
1. Operate the machine at a very low speed to prevent the
bit from slipping off the starting point.
2. Hold a speed and pressure which let cut without
overheating the bit. Apply too much pressure can:
Overheat the drill; Wear the bearings; Bend or burn bits;
and Produce off-center or irregular-shaped holes.
3. When drilling large holes in metal, start with a small bit,
then complete with a large bit. Also, lubricate the bit with
oil to improve drilling action and increase bit life.
MASONRY DRLLING
For maximum performance, use carbide-tipped masonry
impact bits when drilling holes in brick, tile, concrete, etc..
1. Move adjustment button on hammer drill left for hammer
mode.
2. Apply light pressure and medium speed for best results in
brick.
3. When drilling holes in tile, practice on a scrap piece to
find the best speed and pressure. Operate the machine at a
very low speed to prevent the bit from slipping off the
starting point.
5 MAINTENANCE
WARNING
Remove the battery pack from the machine before
maintenance.
WARNING
Do not use strong solvents or detergents on the plastic
housing or components.
5.1 GENERAL MANINTENANCE
• Before each use, examine the machine for damaged,
missing, or loose parts such as screws, nuts, bolts and
caps.
• Clean the machine with a dry cloth. Do not use slovents.
WARNING
Do not let brake fluids, gasoline, petroleum-based materials
touch the plastic parts. Chemicals can cause damage to the
plastic, and make the plastic unserviceable.
CAUTION
Use only approved replacement parts.
6 TECHNICAL DATA
Voltage 24 V
No load speed 0~1000 min
-1
Impact rate 0~4500 min
-1
Single impact force (EPTA) 2.0 J
Concrete drilling diameter 24 mm
Stone drilling diameter 24 mm
Steel drilling diameter 13 mm
Wood drilling diameter 32 mm
Weight without battery 2.47 kg
Battery model G24B2/G24B4 and other
BAG series
Charger model 2913907 and other CAG ser-
ies
Measured sound pressure
level
94.3 dB(A), K
pA
=3 dB (A)
Measured sound power level 105.3 dB(A), K
wA
=3 dB (A)
Vibration 11.7m/s
2
, K=1.5m/s
2
The recommended ambient temperature range:
Item
Temperature
Appliance storage tempera-
ture range
32°F (0°C) - 113°F (45°C)
Appliance operation temper-
ature range
32°F (0°C) - 113°F (45°C)
Battery charging temperature
range
39°F (4°C) - 104°F (40°C)
Charger operation tempera-
ture range
39°F (4°C) - 104°F (40°C)
Battery storage temperature
range
32°F (0°C) - 113°F (45°C)
6
English
EN
Loading ...
Loading ...
Loading ...