Loading ...
Loading ...
Loading ...
FR
VERTUO NEXT / VERTUO POP / VERTUO PLUS
1 Aucun voyant n’est allumé sur
le bouton.
• La machine s’est éteinte automatiquement; appuyez sur le bouton ou
déverrouillez la machine.
• Vérifiez l’alimentation secteur, la prise, la tension et le fusible.
2 Le café et l’eau ne s’écoulent
pas.
• Vérifiez que le réservoir d’eau est rempli.
• Vérifiez qu’une capsule neuve est correctement insérée et que la poignée est
bien verrouillée. Appuyez sur le bouton pour démarrer la préparation du café.
• Procédez au détartrage de la machine si nécessaire.
• Ouvrez la partie supérieure de la machine; la capsule est éjectée
automatiquement. Lancez ensuite la procédure de neoyage conformément
aux instructions figurant à la section «Neoyage» du présent guide.
47
9 Light blinks while machine is
running.
• If coee is flowing normally, this indicates the machine is working
properly.
• If only water is flowing, the machine is executing a user request for either
cleaning, descaling or emptying the system. Refer to the corresponding
paragraph in this user manual.
• Turn the machine to “OFF mode” by pushing the buon for 3 seconds and
then push it again to turn the machine ON. Now wait approximately
20 minutes to allow the machine to cool down aer extensive use.
10 Light blinks and machine is not
running.
• It will take some time before the coee flow comes out (due to barcode
reading and pre-weing the coee).
• Check that a fresh capsule is inserted in correct position, that the handle is
properly locked and push the buon to start.
• Fill the water tank and push buon to start.
• Turn the machine to “OFF mode” by pushing the buon for 3 seconds
and then push it again to turn the machine ON. Now wait approximately
20 minutes to allow the machine to cool down aer extensive use.
11 Light blinks alternately 2 blinks
and 1 pause continuously.
Machine is not running.
• During regular Coee/Espresso preparation: 1) Unlock the handle and
open the machine head to check that a fresh undamaged capsule is
inserted in the correct position.
2) Check that the handle is in “LOCKED” position. 3) Check that the water
tank is filled.
• During Descaling, Emptying and Cleaning: 1) Check that capsule is
ejected. 2) Check that the handle is in “LOCKED” position.
• During Programming Volume: 1) Check if a capsule has been well inserted.
2) Please refer to the corresponding chapter.
• If problem persists:
1. Unlock the handle and open machine head.
2. Replace capsule (if needed).
3. Disconnect powercord from the outlet and plug the machine back into
outlet aer 10 seconds.
4. Close the head and press the buon to turn ON and press again to start
brewing. If problem persists, call Nespresso.
12 Light alternately blinking
3 times and then steady on.
• Descaling needed: machine can be operated when alert appears only a
few times aer this alert before descaling becomes necessary.
VERTUO PLUS
7b Coee leakage. • Open the machine head and let the capsule be ejected. Then perform a
cleaning.
• Empty and clean the cup support.
• Descale if necessary.
• If problem persists, call the Nespresso Club.
Loading ...
Loading ...
Loading ...