Loading ...
Loading ...
Loading ...
Drain connection
This dishwasher is suitable for installing in a raised recess (to attain an ergonomic working height).
This means that the dishwasher can be placed so that the drain hose runs to a lower level than the
bottom of the dishwasher, such as by routing it directly to a floor drain. The dishwasher is fitted with
an integrated anti-siphon device to prevent the machine from being emptied of water during the wash
cycle.
min.
0.6" (14
mm)
Max. 37.4" (950 mm)
The drain hose can also be connected to a connection nipple on the sink unit's water trap. The
connection nipple must have an internal diameter of at least 0.6" (14 mm).
The drain hose may be extended by a maximum of 87" (2.2 m) (the total length of the drain hose must
not exceed 177" (4.5 m)). Any joins and connecting pipes must have an internal diameter of at least
0.6" (14 mm). However, the drain hose should ideally be replaced with a new hose without joins.
No part of the drain hose may be more than 37.4" (950 mm) above the bottom of the dishwasher.
Attach the drain hose with a hose clamp. Ensure that the drain hose has no kinks.
Connection to water supply
Use only the inlet hose supplied with the dishwasher. Do not re-use old or other spare hoses.
The supply pipe must be fitted with a water supply valve. The water supply valve must be easily
accessible, so that the water can be shut off if the dishwasher has to be moved.
Once the installation is complete, turn on the water supply valve and allow the pressure to settle for
a while. Check that all connections are watertight.
Water supply
The machine can be connected to either a cold or a hot (max. 160 °F (70 °C)) water supply. The water
pressure should be 4.2-140 psi (0.03-1.0 MPa).
31
Loading ...
Loading ...
Loading ...