Loading ...
Loading ...
Loading ...
Before You Call
Appliance is not level • Be sure floor is level, strong and stable enough to adequately support range. If floor is
sagging or sloping, contact a carpenter to correct the situation.
• Poor installation. Place oven rack in center of oven and place a level on the oven rack.
Adjust leveling legs at base of appliance until the rack is level.
• Kitchen cabinet alignment may make range appear not level. Be sure cabinets are
square and have sufficient room for appliance clearance.
Convection fan does not rotate. * Oven door is open. Convection fan will turn off if oven door is opened when Convection
is active. Close oven door.
Cannot move appliance easily.
Appliance must be accessible for
service.
Entire appliance does not operate.
Surface burners do not light.
Surface burner flame is orange.
Surface burner flame burns half
way around.
• Cabinets not square or are built in too tightly. Contact builder or installer to make
appliance accessible.
• Carpet interferes with appliance. Provide sufficient space so appliance can be lifted
over carpet.
• Make sure power cord is plugged properly into outlet.
• Electrical power outage. Check house lights to be sure. Call your local electric company
for service outage information.
• Service wiring is not complete. Call 1-800-4-MY-HOME® for assistance (See back
cover).
• Surface control knob has not been completely turned to LITE. Push in and turn the
surface control knob to LITE until burner ignites and then turn control knob to desired
flame size.
• Burner ports are clogged. With the burners OFF, use a small-gauge wire or needle to
clean ports. See the Care and Cleaning section for complete instructions.
• Appliance power cord is disconnected from outlet. Be sure power cord is securely
plugged into the electrical outlet.
• Electrical power outage.
• Dust particles in main line. Allow the burner to operate a few minutes until flame turns
blue.
• In coastal areas, a slightly orange flame is unavoidable due to salt air.
• Burner ports are clogged. With the burner OFF, clean ports by using a small-gauge wire
or needle.
• Moisture is present after cleaning. Lightly fan the flame and allow burner to operate
until flame is full. Dry the burners thoroughly and follow instructions in the Care and
Cleaning section.
31
Loading ...
Loading ...