Ryobi RY40870 40V HP Brushless Whisper Series 24" 2-Stage Cordless Electric Self-Propelled Snow Blower 4 6 Ah Batteries & Charger

OPERATOR’S MANUAL - Page 8

For RY40870. Also, The document are for others Ryobi models: RY40807

PDF File Manual, 40 pages, Read Online | Download pdf file

RY40870 photo
Loading ...
Loading ...
Loading ...
8 — English
NOTICE:
Do not allow the cables connecting the control panel and
chute deflector to become pinched or trapped during
assembly.
INSTALLING CHUTE DEFLECTOR AND
SUPPORT POLE
See Figure 2.
Place the chute deflector onto the support pole.
Insert Torx screws (T25) through holes in support pole
and chute deflector. Tighten securely using Torx wrench
provided.
Lower the chute deflector and support pole onto the
blower housing.
Align the holes in the support pole with the holes in the
blower housing.
Insert the four bolts (M6) into the holes and tighten
securely. Do not overtighten.
INSTALLING THE UPPER HANDLE
ASSEMBLY
See Figure 3.
Loosen and remove the bolts from the four handle knobs
Carefully slide the upper handle into the rails on the snow
blower.
Align the holes in the upper handle with the holes in the
rails.
Insert bolts through the holes in the handle and rails.
NOTE: The head of each bolt should be facing inside.
NOTE: The handle has five hole settings for height
adjustment. Make sure you use the same height setting
for each side.
Install handle knobs and tighten to secure.
ASSEMBLY
OPERATION
WARNING:
Do not allow familiarity with products to make you care-
less. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes resulting in possible
serious injury.
WARNING:
Do not use any attachments or accessories not recom-
mended by the manufacturer of this product. The use of
attachments or accessories not recommended can result
in serious personal injury.
NOTICE:
Before each use, inspect the entire product for damaged,
missing, or loose parts such as screws, nuts, bolts, caps,
etc. Tighten securely all fasteners and caps and do not
operate this product until all missing or damaged parts
are replaced. Please contact customer service or an
authorized service center for assistance.
APPLICATIONS
You may use this product for the purpose listed below:
Removing snow from desired areas such as driveways
and sidewalks
WARNING:
Always remove battery packs or disconnect the snow
blower from power supply when you are assembling
parts, making adjustments, cleaning, or when not in use.
This will prevent accidental starting that could cause
serious personal injury.
INSTALLING/REMOVING BATTERY PACK
See Figures 4 - 6.
NOTE: Always remove any snow or ice accumulation from
around the battery cover before opening.
To install battery packs:
Raise the battery cover.
Align raised ribs on battery pack with grooves in the bat-
tery port and place the battery pack in the snow blower.
Loading ...
Loading ...
Loading ...