Loading ...
Loading ...
Loading ...
Programme options
61
Signal tones
A sequence of signal tones will sound
at the end of the programme or if there
is a fault.
The signal tones at the end of a
programme and the alarm tone in the
event of a fault will sound 4times at
intervals with a short pause between
each set.
The signal tones are switched off as
standard.
You can switch on the signal tones that
sound at the end of a programme if you
wish. The alarm tone that sounds in the
event of a fault is always switched on.
Open the door.
Switch the dishwasher off with the
button, if it is switched on.
Press the button in and, while
holding it in, switch the dishwasher
on using the button.
Keep the button pressed in for at
least 4seconds until the indicator
light comes on.
If this does not happen, start the
procedure from the beginning again.
Press the programme selection
button 4 times.
The top left programme indicator light
will flash rapidly 4 times at intervals.
The flashing sequence in the time
display indicates whether the signal
tones at the end of the programme are
activated or deactivated:
- : Signal tones are activated
- : Signal tones are deactivated
Press the button to change the
setting.
The setting is now stored in memory.
Switch the dishwasher off with the
button.
Loading ...
Loading ...
Loading ...