Loading ...
Loading ...
Loading ...
PAGE: 7 / 10
Remove the motor screws, plastic inserts and
washers from the fan motor assembly.
Secure blade brackets to the motor with washers
and motor screws.
Blade Bracket
Motor Screw
Washer
Fig.12
Tighten fan blades to blade brackets by using
washers and blade screws.
Remove one fix screw (for later use), and loosen the other two
fix screws. Thread the wire through the switch box cover, and
then push the switch box cover upwards by inserting the other
two fix screw heads into key hole slots, rotate the switch box
cover till the round hole in switch box cover aligns the hole in
motor assembly. Finally, secure the switch box cover to motor
assembly with previous fix screw and tighten the other two fix
screws.
Fig.10
Canopy Screw
Key Hole
Slot
Hanger Bracket
Canopy
Decorative Cap
Switch Box
Cover
Key Hole Slot
Round Hole
Fix Screw
Motor
Assembly
Fig.13
Fan Blade
Washer
Fig.11
Blade Screw
Blade Bracket
NOTE: Before installing blade brackets to the
motor, please remove the plastic inserts.
Assembly without fan light
Remove screws from switch box cover first.
Make sure the wires of the fan light in the switch box are capped with
wire connectors.
Connect the two terminals respectively from the switch box cover and switch box.
Secure the switch box onto switch box cover with the switch box screws.
Note: To install the fan light, skip this step and proceed to Fig.15.
Switch Box Cover
Switch Box Screw
Terminals
Slide the canopy up to ceiling and over
the two canopy screws on hanger
bracket. Rotate canopy clockwise, next,
while holding the canopy with one hand,
slide the decorative cap over the screws
and rotate clockwise until tight.
Note: Adjust the canopy screws as
necessary until the canopy and
canopy cover are snug.
Plastic Insert
220607
Loading ...
Loading ...
Loading ...