Loading ...
Loading ...
Important Safety
Instructions (continued)
'!_vff-¢t_tlo[_tOther Precautions
. Never unplug the refrigerator bypulling on the power cord, Always grip the plug
firmly, and pull straight out from the receptacle,
• To avoid electrical shock, unplug the refrigerator before cleaning and before
replacing a light bulb. NOTE: Turning the control to OFFturns off the compressor,
but does not disconnect power to the light bulb or other electricalcomponents,
° Do not operate the refrigerator inthe presence of explosive fumes,
° Avoid contact with any moving parts of the automatic ice maker,
First Steps
Roller Adjusting BoUt
Adjusting Front Rollers
Replacing Toe Grille
This Owner's Guide provides specific operating instructions for your model. Use
refrigerator only asinstructed in this Owner's Guide. Before starting refrigerator,
follow these irrlportant first steps:
Location
Install refrigerator:
• neara grounded electricaloutlet. DO NOTusean extensioncordor an adapterplug.
° out ofdirectsunlight and awayfrom range, dishwasher, or other heatsources,
if possible.
° on afloor that islevel and strong enough to support afully loaded refrigerator.
• where a water supply is available for automatic ice maker.
Installation
. Do not install refrigerator where temperaturewill drop below 60'F (15'C), or rise
above 110'F (43' C). Compressorwill not beableto maintain proper temperatures.
• In a recessed installation, allow an extra 1/2 inch (10-15 mm) or] each side for
ease of installation.
• If the hinge side of the unit will be placed against a wall, allow a 1-,t/4 inch (44
mm) space between wall and refrigerator to permit proper door swing.
Door Opening
Forbest useof drawers and freezer basket, refrigerator should be in a position where
both the refrigerator and freezer doors can be opened about 135'.
Leveling
° Refrigerator must be leveledwith all bottom corners restingfirmly or] asolid floor.
Adjust front rollers to level cabinet both front-to-rear and side-to-side. Keep
cabinetaslow aspossihie for stability. Neverac_iustcabinet rollers so_ont l_lower
than rear,
• To adjust front rollers: Open refrigerator and freezer doors. Remove toe grille
by pulling itstraight out. Adjust rollers byturning each roller adjusting bolt with an
adjustable wrench, a socket wrench, or a nutdriver until refrigerator islevel and
stable, Rearrollers are not adjustable,
° Check both doors to be sure sealstouch cabinet evenly on all four sides,
° If freezer door ishigher than refrigerator door, raiseright corner and/or lower left
corner until doors align acrosstop of cabinet.
° If refrigerator door isbigher than freezer door, raise leftcorner and/or lower right
corner until doors align acrosstop of cabinet.
° To replace toe grille: Line up tabs with holes, and push grille straight on.
Cleaning
, Wash the inside, all removable parts, and the outside with mild detergent and
warm water. Wipe dry. Do not use harsh cleaners on these surfaces.
° Do not use razor blades or other sharp instruments that can scratch appliance
surface, when removing adhesive labels. Any glue left from the tape or energy
label can beremoved with a mixture of warm water and mild detergent, or touch
glue with sticky side of tape already removed.
, Do Not Remove Serial Plate.
Loading ...
Loading ...
Loading ...