Loading ...
Loading ...
Loading ...
Automatic ice and
Water Dispenser
(continued)
Order new filter cartridges through the
dealer where you bought the
refrigerator, or contact the Frigidaire
Consumer Assistance Center at 1-800-
944-9044, it might be good to order
some filters when you first install your
refrigerator. Be sure to ask for the RC-
200 PureSource Plus TM replacement
cartridge.
The PureSource Plus TM RF-200 ice and
water filter system is tested and certified
by NSF international, the nationally
recognized and respected, not for profit,
certification organization for public
health safety. The PureSource Plus TM
system is tested and certified to ANSI/NSF
Standards 42 and 53. See performance
data sheet for specifications. This system
should not be used on water that is
microbiologicaiiy unsafe or with water of
unknown quality unless the water has
been adequately disinfected before or
after traveling through the filtration
system.
Rated service flow- .37 GPM
Maximum Rated Pressure- 325 PSi
Maximum Operating Temp. - 100 °
Changing the Filter:
Water quality varies throughout the world To ensure the highest possible water
quality, change water filter every 6 months, or 200 gallons Also, if filter hasbeen
in a refrigerator that has not been in use for awhile (during moving for example),
change filter before reinstalling refrigerator Note dispenser systemwill also operate
without filtration (with filter cartridge removed)
To change filter:
Referto Figure1 asneeded It isnot necessaryto turn the water supply off to change
the filter
1 Set ice maker lever (wire signal arm) to the OFF(up) position
2 Hold filter cup firmly, and unscrew counter clockwise (Figure 1) (Some water
could leak out asyou remove cup This isnormal,) Filter cartridge should come
down with cup Ifcartridge remains in housing, pull down gently, while twisting
filter back and forth
3 Empty cup of any substance
4 The large o-ring (Figure 1) that sealsthe filter system sets in the o-ring groove
down insidethe cup Should the o-ring fall out during filter cartridge replacement,
simply place it back in the groove prior to screwing the cup back in place If the
o-ring becomes damaged, you will need to order one from the Consumer
Assistance Center,
5. Discard old filter cartridge.
6, Remove new filter cartridge from packaging, and install,
7, Placefilter cartridge in cup, The end with the small o-ring should be up, out
of the (:up.
8, Screw cup, with filter, back onto housing. Do Not Use Wrench To Reinstall
Cup. Filter cartridge will self-align ascup istightened. Be surecup iscompletely
tightened with PureSourcePlus TM logo facing outward, Do Not Tighten Past
Stop,
9, Set ice maker lever on the ON (down) position,
10,Check for leaks,()pen refrigerator door, Wipe any water dropsfrom the filter cup,
Run a glass of water. If there is a leak, unscrew filter cup, and reinser[ the filter
cartridge, Check placement of large O-ring (see Figure1), Reinstall filter cup,
making certain it istightened completely,
11 ,To condition filter system and purge air from water line, run several glassesof
water through water dispenser, This will also assurethat the purest water
possible is stored in water tank,
IMPORTANT
After replacing the filter cartridge, it will be necessary to reset the filter use up
indicator that is located on the ice and water dispenser Pressthe ' Change Water
Filter" pad If the indicator light wasred or amber, you will need to pressthe pad for
3-5 secondsto reset Ifthe light was still green you will need to pressthe pad for 10-
12 secondsto reset Thelight will flash on and offwhen reset iscomplete Pleaserefer
to the cornplete dispenser operating instructions attached to the insideof the freezer
door
\\\\\\
• \
Small O-rin_
Cartridge
Figure 1
10
TWIST TO REMOVE
Loading ...
Loading ...
Loading ...