Loading ...
Loading ...
Loading ...
Configuring light settings
51Inspire Series User Manual
020-001934-02 Rev. 1 (01-2022)
Copyright ©2022 Christie Digital Systems USA Inc. All rights reserved.
Logging on to the web user interface
Log on to the web user interface by following the steps below.
1. Connect the projector to AC and power it on.
2. When network is available, connect the projector and computer to the same network.
a. To check the projector address in a wired network, select Menu > Configuration >
Communications > LAN > IP Address.
b. To check the projector address in a wireless network, select Menu > Configuration >
Communications > WLAN > Default Gateway.
3. If network is unavailable, connect the projector to the computer with an RJ45 cable.
a. Set the Default Gateway and Subnet Mask of the computer to match the projector.
b. Set the IP address of the computer to match the first three numbers of the projector.
For example, if the projector IP address is 192.168.000.100, set the computer IP address
to 192.168.000.xxx, where xxx is not 100.
4. Open a web browser and type the projector address in the browser address bar.
5. In the Username field, type the username.
The default username is admin.
6. In the Password field, type the password.
The default password is projector serial number.
7. Click Login.
Using the web interface
To control the projector through the web interface, do the following:
1. Start up the web browser on your computer or mobile devices.
2. Enter the IP address set on the projector into the URL of the web browser.
3. Enter the user name and password to login. After a successful login, you can control the
projector over the web interface.
Using the RS-232C interface
To control the projector through the RS-232C interface, do the following:
1. Connect your computer and the projector directly using the RS-232 cable.
2. Set the same baud rate in both your computer and projector. Use commands to control the
projector.
Loading ...
Loading ...
Loading ...