Loading ...
Loading ...
Loading ...
9
ADJUSTMENTS & USAGE GUIDE
1. If you find there is no difference between tension level 1 to level 8, please check the
connection of the tension cable. Please see Diagram A under Step 2.
2. If the meter does not show numbers correctly, please check the batteries. If the meter
does not count the speed and time, please check the connections of Upper Sensor Wire
(No. 15) to the Meter (No. 108) and Upper Sensor Wire (No. 15) to Lower Sensor Wire
(No. 16).
3. If you have difficulty putting Hinge Bolts (No. 105L/R) into the Crank Arm (No. 106),
please try moving the Crank Arm (No. 106) to a different angle. *Keep in mind the Left
Hinge Bolt (No. 105L) has reversed threading and must be installed by turning
counter-clockwise.
4. If you hear any noise when using the machine, please check if Hinge Bolts (No. 105L/R),
Hex Bolts (No. 21), Hex Bolts (No. 25) and Connecting Joints (No. 107) are loose.
You may remove these parts and add some lubricant oil to eliminate all noise possibilities.
Remember to tighten all the parts securely.
5. If it is very hard to pedal on the higher tension levels, or you hear rubbing noises, please
remove the Belt Cover (No. 65L/R), and adjust the screw seen in the following diagram.
You will need to lower the position of the screw by turning counter-clockwise. This will
keep the Magnet Board (No. 84) from contacting the magnetic flywheel. Before
re-installing the Belt Cover (No. 65L/R), test the tension level 8 to ensure the magnets
do not touch the flywheel.
Loading ...
Loading ...
Loading ...