Loading ...
Loading ...
Loading ...
Note
●
Auto Light is disabled when any one of
the conditions below exists.
ー
Alarm, timer alert, or other beeper
sounding
●
Configuring the Auto Light Setting
1. Enter the Timekeeping Mode.
l
Navigating Between Modes
2. Hold down (L) for at least three seconds
to toggle Auto Light between enabled and
disabled.
●
[LT] is displayed while Auto Light is
enabled.
●
If you do not disable it manually, Auto
Light remains enabled for
approximately six hours. After that, it
becomes disabled automatically.
On
Note
●
While the setting is being configured,
the watch will exit the setting operation
automatically after about two or three
minutes of non-operation.
●
Specifying the Illumination Duration
You can select either 1.5 seconds or three
seconds as the illumination duration.
1. Enter the Timekeeping Mode.
l
Navigating Between Modes
2. Hold down (A) for at least two seconds.
Release the button when the seconds
start to flash.
●
This enters the setting mode. The
hands automatically shift out of the way
for easy viewing of the screen.
Seconds
3. Press (C) nine times.
This causes [LT1] or [LT3] to flash on the
display.
4. Press (D) to select an illumination
duration.
[LT1]: 1.5-second light
[LT3]: 3-second light
5. Press (A) to exit the setting screen.
Time Adjustment
Use the procedures in this section to adjust the
date and time settings.
Adjusting the Current Time
Setting
Use the procedures in this section to adjust the
date and time settings.
●
Setting the Time/Date
1. Enter the Timekeeping Mode.
l
Navigating Between Modes
2. Hold down (A) for at least two seconds.
Release the button when the seconds
start to flash.
●
This enters the setting mode. The
hands automatically shift out of the way
for easy viewing of the screen.
Seconds
Watch Operation Guide 5692
8
Loading ...
Loading ...
Loading ...