Loading ...
Loading ...
Loading ...
Battery charger
LED on the battery
charger
Cause Solution
The error LED flashes
or comes on.
The battery charger is
too cold or too hot to
use.
Let the battery charger cool down or move it indoors to warm
it up. When the battery charger has the correct temperature, it
can be used again. Use the battery charger when the ambient
temperature is 5 °C–40 °C.
Other errors. Speak to your Husqvarna servicing dealer.
Lawn mower
The warning indicator (error LED) is found below the
battery lid.
Problem Error LED (number
of flashes)
Cause Solution
Error LED flash-
es. The product
does not operate
correctly.
5 The blade is blocked. Turn the safety key to 0 to prevent ac-
cidental start. Remove the battery and
wait a minimum of 5 seconds. Remove
possible obstacles and make sure that
the blade can rotate freely. If the prob-
lem continues, speak to your Husqvarna
servicing dealer.
The motor speed drops too
much, and the motor stops.
Increase the cutting height. Refer to
To
set the cutting height on page 14
.
6
1
The wheels or transmission is
blocked.
Turn the safety key to 0 to prevent ac-
cidental start. Remove the battery and
wait a minimum of 5 seconds. Remove
the possible obstacles and make sure
that the wheels can rotate freely. If the
problem continues, speak to your Husq-
varna servicing dealer.
10 The motor control is too hot. Stop the motor and wait until it has be-
come cool.
Error LED flashes.
The product stops.
0 Battery connector failure. Examine the battery connector.
3 There is overload in the mo-
tor.
Increase the cutting height. Refer to
To
set the cutting height on page 14
.
8 The battery is weak. Charge the battery. Refer to
To charge
the battery on page 14
.
9 Battery error or no signal from
battery.
Put the battery in the product correctly
and examine the battery connector. If the
error LED on the battery flashes. Refer
to
Battery on page 17
.
12 Incorrect start procedure. The
motor brake handle has been
engaged before the motor
starts.
Release the motor brake handle and
wait approximately 5 seconds. Push the
motor brake handle down again to start
the product.
1
Only for LC 142iS
18 1692 - 006 - 22.08.2023
Loading ...
Loading ...
Loading ...