Loading ...
Loading ...
Loading ...
m
Door Removal and Reversal Instructions (continued)
NOTE: Some models have "pocket" handles, which are recessed into the sides of the door. On these models, only the
hinges will need to be reversed.
TO REMOVE FREEZER HANDLE:
_Handles may Deeasier to reverse while doors are off.
1. Remove two screws attaching qandle to bottom of freezer door.
2. Swing bottom of handle away from the door and slide handle straight
UDand off of dovetail button.
3. Remove screw and dovetail button and installon other side. moving
qole plugs from corresponding holes to opposite side.
TO ATTACH FREEZER HANDLE:
1. Start with handle offset away from door. Place top of handle over
dovetail button, swing handle intoan upnght position and pull
downward, locking _t_ntoplace.
2. Secure bottom of handle with two screws removed earlier
LockHandle
over
TRIM REMOVAL (FULL-LENGTH TRIM MODELS ONLY)
In some models, the refrigerator door has a full length trim piece which continues from the bottom of the handle to the
bottom of the door. The top of the trim fits around the base of the handle. An adhesive "tdm lock" ispositioned about halfway
down. The bottom of the trim is held inplace by either an adhesive trim lock, or a tdm lock with two prongs inserted intoa
hole on the face of the door.
TO REMOVE TRIM:
1. Remove trim by gently pulling trim lock areas out and away from door.
2. When trim isfree from door, slide the trim straight down and away from base of handle.
NOTE: For models with short handle trim, remove by sliding trim straight down and off of handle bracket.
TO REMOVE REFRIGERATOR HANDLE:
Handles may be easier to reverse while doors are off.)
1. Remove two screws attaching handle to top of refrigerator door.
2. Swing top of handle away from door and slide handle down and off of
dovetail button.
3. Remove screw and dovetail button and install on other side, moving
hole plugs from corresponding holes to opposite side.
TO ATTACH REFRIGERATOR HANDLE:
1. Start with handle offset away from door. Place bottom of handle over
dovetail button, swing handle intoan upright position and pull upward,
locking it into place.
2. Secure top of handle with screws.
TO ATTACH TRIM:
1. Slide both tdm locks out of trim.
2. Insert new adhesive trim locks contained in your literature pack.
NOTE: Trim lock must be removed and installed by sliding over the
two donut shaped areas.
3. Install trim to handle by sliding over base of handle. Carefully align
trim and press down at trim lock locations.
4. Replace hole plug on opposite side. Use rubbing alcohol to remove
any adhesive residue from old trim lock locations.
I
Lock Handle
ovsr
Dovetail
Dovetail
uttorl
__.Adhesive
_Trim Lock
Full
Trim
8
Loading ...
Loading ...
Loading ...