Loading ...
Loading ...
Loading ...
O
O
INSTALLINGMACHINE HEAD IN PORTABLEAND CABINET
Loosen the two hinge screws under holes in the rear edge of
the machine bed (1).
Raise hinge pins in the cabinet cutout (2).
Slip machine head onto the pins and tighten hinge screws
securely (3).
Lower machine head to front flap.
Screw spool pins in place. Lay the plastic discs over the spool
pins. Discs and pins are packed in the accessory box.
SEWING LIGHT
The sewing light is located inside the face plate as shown.
It may be turned on or off by pushing the light switch. To re-
move the bulb, disconnect the sewing machine and swing open
the face plate. Push bulb in slightly, turn it counterclockwise
and remove. To replace, push new bulb in and turn clockwise.
See illustration 4.
CONNECTINGMACHINE
Push foot or knee control connector onto three-prong connector
under the machine bedplate. See illustration 5. Push the two
prong plug of the control into any 110-120 V. wall outlet.
Loading ...
Loading ...
Loading ...