Loading ...
Loading ...
Loading ...
WITH
1.
2.
DARNING
PRESSER FOOT:
Turn feed dog control to left.
Pressdown outer ring of presser foot pressure regulator, see page 10. With regulator in this posi-
tion mending, monogram work, etc. may be done.
3. Stretch fabric tightly between two spring embroidery hoops and place under needle. The presser
bar can be raised to accommodate the embroidery hoop by pulling up on the presser foot lever.
4. Lower presser bar so thread will have some tension. When you start to darn, move fabric back
and forth to cover darning area. Then turn fabric and continue sewing at right-angels to the pre-
vious stitching. Always use medium machine speed. You can make any length stitches desired.
_low movement of fabric will make short darning stitches. Fast movement will make long
stitches.
5. When you Finish darning, raise presserfoot and remove fabric. Increase pressure of presser foot
for general sewing by pressing center pin of presser foot pressure regulator. Turn feed dog
control to right.
WITHOUTPRESSER FOOT:
1. Turn feed dog control to left.
2. Remove presser foot.
Proceed as directed under steps 3 and 4 above.
3. when you finish darning, raise the presser bar and remove fabric. Replace presser foot.
Turn feed dog control to right.
20
Loading ...
Loading ...
Loading ...