Loading ...
Loading ...
Loading ...
16
VISCA Control:
The HD-NDI-200 is able to be controlled via RS485 VISCA or VISCA over IP.
To setup RS485, please locate the RS485 terminal block on the breakout cable.
To setup VISCA over IP, please use the RJ45 port and connect it to your software
or hardware that helps control camera parameters. Here are some specs on
controlling the camera over IP:
Control Port: RJ-45 Gigabit LAN
IP Protocol: IPv4
Transmission Protocol: TCP/UDP
IP Address: Default (192.168.1.188) Check OSD menu for more info
Port Address: 52381
Confirm send/transmission control: Depends on software
What is VISCA over IP?
VISCA commands are the communication between the controller and the camera
equipment. These commands are sent via UDP on the network. Since UDP
transmission isn’t that stable, a couple of steps must happen before a setting is
executed. The controller first sends out a VISCA command. The camera
equipment then receives the VISCA command and returns that message aback to
the controller. Once that command is executed, the action will follow suit and the
message will be complete. Each VISCA command controls its own setting, so there
are no overlaps in existing commands.
Loading ...
Loading ...
Loading ...