Loading ...
Loading ...
Loading ...
Surface Cooking EXPANDABLE RADIANT HEATING UNITS (some models)
This heating unit adapts to both small and large heating utensils. The unit control dial has a dual set
of graduations Forsmall utensils usethe right side of the control dial; for large utensils the left. Only
the inner surface of the unit heats when using it for small utensils; the whole surface heats for large
utensils The hot surface and surface indicator lights will glow when the heating unit is turned ON
Note: During any heat setting of the outer radiant eiement, the inner radiant eiement cycles on
and off with the outer eiement.
Expandable Radiant Element
Control Dia!
Indicator Lights
Two different surface controi lights will glow on your range: Surface Indicator Lights and Hot
Surface Indicator Lights.
• The surface indicator lights, located on the control panel, glow when any surface unit is
turned on. A quick glance at the lights after cooking is an easy check to be sure all surface
controls are turned off.
•The hot surface indicators lights, located under the glass cooktop, will come on asthe
surface cooking area heats up and will continue to glow until the glasscooktop hascooled down
to a moderate ievei. The iights may remain on even though the controis are turned to OFR
Oven Vent(s) and Racks
Some models are equipped with a blower which runs in baking and self-cleaning mode to keep
all internal components at a cool temperature. It is possible that the blower keeps running even if the range has
been turned off, until the components have cooled down.
Oven Vent Location OvenVent Oven Vent Location
Location The oven is vented at the right side front panel and visibte
........ when the oven door is open or through the right rear col
eiement. See illustration for the exact location. When the
oven is on, warm air is released through the vent(s). This
venting is necessary for proper air circulation in the oven and
good baking results. DO NOT block the vent(s). Doing so may
cause cooking failures, fire or damage to the appliance.
Arranging Oven Racks
ALWAYS ARRANGE OVEN RACKS WHEN THE OVEN IS COOL (PRIORTO OPERATING THE
OVEN). Always use oven mitts when using the oven.
To remove an oven rack, pull the rack forward until it stops. Lift up front of rack and slide out.
To replace an oven rack, fit the rack onto the guides on the oven walls. Tilt the front of the
rack upward and slide the rack back into place.
Changing Oven
Light
Be sure the oven is unplugged and all parts are COOL before replacing the oven
light bulb. Do not turn the oven light on during a self-cleaning cycle. High temperature witl
reduce Iamp life.
On some modeis an interior oven light will turn on automatically when the oven is opened.
The oven light may be turned on when the door is closed by using the oven light switch located
on the Electronic Oven controi.
On a self-cleanning oven the Iamp is covered with a glass shield held in place by a wire holder.
THIS GLASS SHIELD MUST ALWAYS BE IN PLACE WHEN THE OVEN IS IN USE.
To Replacethe Light Bulb:
BE SUREOVEN IS COOL
1. Turn the power off at the main source.
2. Wear a leather-faced glove for protection against possible broken glass.
3. Replace bulb with a 40 Watt appliance bulb only,
4. For self-cleaning oven, presswire holder to one side to release glass shield, change bulb and
be sure to replace glass shield.
12
Loading ...
Loading ...
Loading ...