1. Home
  2. Ancona
  3. Ancona AN-22118SS User Manual
  4. Page 13

Ancona AN-22118SS 2-piece Kitchen Appliance Package with 36" 6-burner Gas Cooktop with 1200CFM Undercabinet Range Hood

User Manual - Page 13

For AN-22118SS. Also, The document are for others Ancona models: AN-2160, AN-2161, AN-2162, AN-2230SS, AN-2236SS, AN-2248SS, AN-2230WHT, AN-2236WHT, AN-2248WHT, AN-2230SSBK, AN-2236SSBK, AN-2248SSBK

PDF File Manual, 55 pages, Read Online | Download pdf file

AN-22118SS photo
Loading ...
Loading ...
Loading ...
— 13 —
IMPORTANT:
• Observeallgoverningcodesandordinances.
• It is the customer’s responsibility to contact a qualified electrical installer.
• Ifcodespermitandaseparategroundwireisused,itisrecommendedthataqualifiedelectriciandeterminethat
thegroundpathisadequate.A120-Volt,60Hz,AC-only,fusedelectricalsupplyisrequiredonaseparate15-amp
circuit, fused on both sides of the line.
• DONOTgroundtoagaspipe.
• Checkwithaqualifiedelectricianifyouarenotsurethattherangehoodisproperlygrounded.
• DONOThaveafuseintheneutralorgroundcircuit.
IMPORTANT: Save this Installation Guide for electrical inspector’s use.
GROUNDING INSTRUCTIONS:
• Thisappliancemustbegrounded.Intheeventofanelectricalshort-circuit,groundingreducestheriskofelectric
shock by providing an escape wire for the electric current.
• Thisapplianceisequippedwithacordhavingagroundingwirewithagroundingplug.Theplugmustbeplugged
into an outlet that is properly installed and grounded.
WARNING: Improper grounding can result in a risk of electric shock.
• Consultaqualifiedelectricianifthegroundinginstructionsarenotcompletelyunderstood,orifdoubtexistsasto
whether the appliance is properly grounded. DO NOT use an extension cord. If the power supply cord is too short,
have a qualified electrician install an outlet near the appliance.
Installation
STEP 10
Install Filters
Toinstallfilters,followfourstepsbelow(seefigure9):
•Angle the lter into slots at the back of the hood.
•Push the button on handle of the lter.
•Release the handle once the lter ts into a resting position.
•Repeat to install all lters.
Figure 9
STEP 9
Connect to AC
•ConnectACplugintoagroundedACoutlethaving120V,60Hz.Placetheoutletatamaximumdistanceof33-1/2in.
(851 mm) from where the cord exits on the hood.
•SEE IMPORTANT INSTRUCTIONS ON THIS PAGE.
3-Pronged Plug
Ground Plug
3-Prong Receptacle
Loading ...
Loading ...
Loading ...