Loading ...
Loading ...
Loading ...
TROUBLESHOOTING POINTS
PROBLEM
Engine continues to ran
when operator leaves seat
with attachment clutch
engaged
Poorcut-uneven
Mower blades will not
rotate
Poor grass dl,_¢harge
Headlight(s] not working
(if so equipped)
Battery will not charge
Tractor "creeps" with
motion control lever m
"neutral" position
(Fender shift models only)
Loss of drive
Engine "backfires"
when turning engine
"OFF"
CAUSE
t. Fautty operator-safety presence control system.
1. Worn. eem or loose b!ade
2. Mower deck not level
3. Buildup of grass, leaves, and trash under mower.
4. Bent blade mandrel
5. Clogged mower deck vent holes from buildup of
grass, leaves, and trash around mandrels
1. Obstruction in clutch mechanism
2. Worn/damaged mower drive belt
3. Frozen idler pulley,
4 Frozen blade mandrel.
1 Engine speed too slow.
2 Travel speed too fast.
3. Wet grass.
4 Mower deck not level.
5. Low/unever tire air oressure.
6. Worn bent or loose blade.
7. Buildup of grass, leaves and trash unaer mower
8. Mower drive behworn.
9. Blades imDrooenyinstalled.
10. ImDroDer blades used
lt. Clogged mower deck vent holes from buildup of
grass, leaves and trash around mandrels
1. Switch is "OFF".
2. Bu]bfs) r_umed out.
3. Faulty lignt switch
4. Loose or damaged wiring.
5. Blown fuse.
1. Bad battery cel!(s).
2. Poor cable connections.
3. Faulty regulator {if so equ=pped).
4. Faulty alternator.
1_ Motion control lever is out of adjustment.
1. Freewheel centre] in "disengaged" pos=tion.
2. Motion drive belt worn. damaged, or broken.
3. Air trapped in transmission during shipment
or servicing.
1. Engine throttle control not set at"SLOW"
position for 30 seconds before stopping engine
CORRECTION
3. Check wiring, switches and connections. If not
corrected contact an authorized service center/
aena_tment.
1 Replace blade. Tighten blade bolt.
2. Level mower deck.
3. Clean underside of mower housing.
4. Replace blade mandrel
5 Clean around mandrels to open vent holes
] Remove obstruction
2 Replace mower drive belt.
3. Replace idler pulley.
4. Reelace blade mandrel.
1. Place throttle contro! in "FAST" posltlor
2 Shift to slower sDeed.
3. Allow grass to dry before mowing.
4_ Level mower deck
5. Check tires for proper a=rpressure.
6. Replace/shah)an blade. Tighten blade bolt.
7 Clean underside of mower housing.
8 Replace mower _rive belt.
9 Reinstall blades sharp edge sown.
10 Replace with blades listed in this manual
11 Clean around mandrels to eden vent holes.
! Turn switch "ON".
2. Replace bulb(s).
3. Check/reolace light switcl
4. Check wiring and connections.
5. Replace fuse
1. Reelace battery.
2. Check/clean aJlconnections.
3. RepJace reguJator.
4. ReDlace alternator.
1 Adjust motion controllever.
t. Place freewheel control _n"engaged" position,
2. Replace motion drive belt.
3. Purge [ransm_ssion.
Move throttle control to "SLOW" position and allow
to idle for 30 seconds before stopping engine.
30
Loading ...
Loading ...
Loading ...