Loading ...
Loading ...
Loading ...
3.1.6 Adjust the LOWER STEM (12) so that when you stand upright with the detector in
you hand, the SEARCH COIL (14) is level with and about 1/2 to 2 inches above the
ground with your arm relaxed at your side.
3.1.7 Tighten the STEM LOCK NUT (8) in reverse direction (counterclockwise) to lock it in
place.
3.1.8 Loosen the SEARCH COIL KNOBS (13) at the SEARCH COIL ASSEMBLY (14),
then adjust the search coil to the desired angle. (The Search Coil should be parallel with
the ground.) Tighten the knobs just enough to keep the search coil from rotating or
wobbling.
3.1.9 Loosen the 1 screws at the bottom of the ARMREST. Adjust the armrest so that it
should be near to the end of your forearm. Tighten the 1 screws in the reverse direction.
3.2 INSTALLING BATTERIES
You need 6 1.5V AA alkaline batteries to power your detector.
3.2.Press the POWER button on the control panel to make sure that the detector is OFF
3.2.2 Slide the battery cover away from the BATTERY COMPARTMENT (9).
3.2.3 Insert 6 new batteries into the BATTERY COMPARTMENT. Cares should be taken
for the polarities symbols (+ and -) which are marked on the connection terminals of the
detector and the batteries. The polarities of the battery must be matched with the
polarities of the terminals.
Loading ...
Loading ...
Loading ...