Loading ...
Loading ...
Loading ...
4.3 OPERATION INSTRUCTION
4.3.1 Normal Operation State
Turn on the detector by pressing on the POWER button once.
The SENS and DEPTH icons (with other icons) should appear on the display.
The detector enters in the Normal Operation State.
Press the POWER again will turn off the power supply to the detector.
4.3.2 Batteries Condition Indicator
Indicates the conditions of the batteries in the battery box. There are 4 levels or
segments.
All 4 segments appeared indicates the batteries are in good condition.
One segment is the minimum power at which the device can be operated. When the
indicator reaches this level and is flashing, it is time for replacing batteries.
4.3.2 Sensitivity Adjustment
In the Normal Operating State (Ref to 4.3.1), press on the SET button The SENS icon is
flashing.
Press the ENTER to confirm the setting and return to the normal Operating State.
NOTE: There are 8 steps or segments of sensitivity level. The more segments displayed,
the higher the sensitivity level. High level of sensitivity should always be used for
searching since high level of sensitivity can detect deepest and smallest targets, however
at high level of sensitivity you will face the problem of False Signal (refer to 4.4.5) which
prevent you from setting higher sensitivity. A False Signal occurs when something
shouldn t sound like a good target. This is caused by highly mineralized ground or
interference from power lines, radio station, etc. As a general rule, reduce sensitivity to
prevent excessive false signal.
4.3.3 Targets Eliminate Setting
In the Normal Operating State, press the SET button (twice) until the highlight icon is
flashing. The ferrous nail encircled by the highlight icon means that it is selected.
Loading ...
Loading ...
Loading ...