Loading ...
Loading ...
Loading ...
8.6 INSTALL THE AUXILIARY
HANDLE
1. Turn the handle counterclockwise to loosen the handle
assembly
.
2. Move handle into desired position.
3. Turn the handle clockwise to tighten.
NOTE
Make sure the auxiliary handle is tightly connected to the
depth stop rod clamp. This attaches the depth stop rod at the
necessary depth of cut. It also holds the auxiliary handle.
9 OPERATION
W
ARNING
Always wear eye protection.
WARNING
Do not use any attachments or accessories not
recommended by the manufacturer of this product.
9.1 START THE MACHINE
NOTE
The machine can not work until the forward / reverse switch
is pushed fully to the left or right. Do not operate the
machine at low speeds for extended periods of time.
1. Pull the trigger to turn the machine ON.
Variable speed
The machine has a variable speed switch that delivers higher
speed with increased trigger pressure and lower speed with
decreased trigger pressure.
9.2 STOP THE MACHINE
1. Release the trigger to turn the machine OFF.
W
ARNING
Release the trigger and allow the machine to come to a
complete stop.
9.3 FORWARD / REVERSE SWITCH
The machine has the switch(forward/reverse) above the
switch trigger to change the rotation.
1. When the switch is on the left side of the switch trigger,
the bit direciton is forward (tightening).
2.
When the switch is on the right side of the switch trigger,
the bit direction is reversed (loosening).
3. Put the forward/reverse siwtch in the OFF (center lock)
position to help decrease the possibility of accidental
starting when not operating.
W
ARNING
Release the trigger and allow the machine to come to a
complete stop.
W
ARNING
Let the chuck to come to a complete stop before changing
the direction of rotation.
8
English
EN
Loading ...
Loading ...
Loading ...