Loading ...
Loading ...
Loading ...
1. Operate the machine at a very low speed to prevent the
bit from slipping of
f the starting point.
2. Hold a speed and pressure which let cut without
overheating the bit. Apply too much pressure can:
Overheat the drill; Wear the bearings; Bend or burn bits;
and Produce off-center or irregular-shaped holes.
3. When drilling large holes in metal, start with a small bit,
then complete with a large bit. Also, lubricate the bit with
oil to improve drilling action and increase bit life.
MASONRY DRLLING
For maximum performance, use carbide-tipped masonry
impact bits when drilling holes in brick, tile, concrete, etc..
1. Move adjustment button on hammer drill left for hammer
mode.
2. Apply light pressure and medium speed for best results in
brick.
3. When drilling holes in tile, practice on a scrap piece to
find the best speed and pressure. Operate the machine at a
very low speed to prevent the bit from slipping off the
starting point.
10 MAINTENANCE
W
ARNING
Remove the battery pack from the machine before
maintenance.
W
ARNING
Do not use strong solvents or detergents on the plastic
housing or components.
10.1 FIT AND CHANGE THE SDS BIT
This machine is equipped with an SDS Plus connection
system.
1.
Clean the bit and grease it with machine grease before
inserting it into the chuck.
2. Pull back the clamp collar and hold it.
3. Push and turn the dust-free tool into the bit holder as far
as it can go.
4. Release the clamp collar to lock the bit.
5. Examine that bit has locked by pulling on it.
10.2 CLEAN THE MACHINE
CAUTION
The machine must be dry. Humidity can cause risks of
electrical shocks.
• Clear the unwanted material out of the air vent with a
vacuum cleaner
.
• Do not spray the air vent or put the air vent in solvents.
• Clean the housing and the plastic components with a
moist and soft cloth.
11 TECHNICAL DATA
Voltage 24 V
NoLload Speed 0~1000 min
-1
Impact Rate 0~4500 min
-1
Single Impact force (EPTA) 2 J
Concrete Drilling Dia 24 mm
Stone Drilling Dia 24 mm
Steel Drilling Dia 13 mm
Wood Drilling Dia 32 mm
Weight Without Battery 5.44 lbs
Battery Model BAG709 and other BAG ser-
ies
Charger Model CAG801 and other CAG ser-
ies
The recommended ambient temperature range:
Item Temperature
Appliance storage tempera-
ture range
32°F (0°C) - 113°F (45°C)
Appliance operation temper-
ature range
32°F (0°C) - 113°F (45°C)
Battery charging temperature
range
39°F (4°C) - 104°F (40°C)
Charger operation tempera-
ture range
39°F (4°C) - 104°F (40°C)
Battery storage temperature
range
32°F (0°C) - 113°F (45°C)
Battery discharging tempera-
ture range
32°F (0°C) - 113°F (45°C)
12 LIMITED WARRANTY
YEAR
A
N
S
AÑOS
LIMITED WARRANTY
GARANTIE LIMITÉE
GARANTÍA
LIMITADA
3
Greenworks hereby warranties this product, to the original
purchaser with proof of purchase, for a period of three (3)
years against defects in materials, parts or workmanship.
Greenworks, at its own discretion, will repair or replace any
and all parts found to be defective, through normal use, free
of char
ge to the customer. This warranty is valid only for
units which have been used for personal use that have not
been purchased or rented for industrial/commercial use, and
10
English
EN
Loading ...
Loading ...
Loading ...