Loading ...
Loading ...
Loading ...
28
4 IMMO
The IMMO application provides Smart Mode and Expert Mode to guide
technicians performing IMMO related functions, including Key Learning,
Remote Control Learning, Remote Control Add, etc.
Establish Vehicle Communication
The IMMO operations require connecting the MaxiIM IM608 tablet to the test
vehicle through the MaxiFlash using the main cable and the included USB
cable (2m). To establish proper vehicle communication to the tablet, you need
to perform the following steps:
1. Connect the MaxiFlash to the vehicle’s DLC for both communication and
power source.
2. Connect the MaxiFlash to the tablet via BT pairing, or USB connection.
3. When the above steps are completed, check the VCI navigation button
at the bottom bar on the screen, if a green check displays at the lower
right corner, the MaxiIM IM608 is ready to start vehicle diagnosis.
Vehicle Connection
The method used to connect the MaxiFlash to a vehicle’s DLC depends on
the vehicle’s configuration as follows:
A vehicle equipped with an On-board Diagnostics Two (OBD II)
management system supplies both communication and 12-volt power
through a standardized J-1962 DLC.
A vehicle not equipped with an OBD II management system supplies
communication through a DLC connection, and in some cases supplies
12-volt power through the cigarette lighter receptacle or a connection to
the vehicle battery.
Loading ...
Loading ...
Loading ...