Loading ...
Loading ...
Loading ...
www.NutrichefKitchen.com
13
11. Automatic memory saving function
When the program is nished and the machine is shut down after running every time, the running
program and settings will be saved automatically. When the machine is started up again next time,
the running program and settings of last time will be retrieved from the memory automatically and
run again.
CLEANING AND MAINTENANCE
Cleaning your Beer Brew Automatic after use:
After use you should empty the brew kettle of any remaining trub. Use warm water and a soft kitchen
brush only to gently clean the equipment. You can also use a PBW cleaner to soften any burnt material in
the bottom of the brew kettle.
Add about 5-10 litres of water, press “On” on the brew controller display, switch the brew program selector
to “II”, then press “Run”. Connect the whirlpool arm. When the water is boiling, open the riser pipe valve
and switch on the pump and let it run for about 5 minutes in order to clean the equipment pipes and
pump, then switch the equipment o. Empty the brew kettle, dry of the equipment and store until your
next brewing session.
Note:
Do not use a hard brush as it can create scratch marks on the equipment surfaces.
Do not submerge the base of the brew kettle in water.
Cleaning the pump:
Sometimes some material can get into the pump, preventing the impeller inside the pump front casing
from running. In case of clogging you may need to take the pump out for manual cleaning.
Ensure that the Home Beer Brewing Machine is empty and cooled down to approximately room
temperature. Disconnect the power cord from the wall outlet and place the brew kettle upside down.
#3
#2
#1
#5
#4
Loading ...
Loading ...
Loading ...