Loading ...
Loading ...
Loading ...
Basic Jointer/Planer Cutting Operations (continued)
Sliding Fence Operation
WARNING: Moving parts can injure. Tu-rn jointed _ Sliding Knob
planer off and wait for all parts to stop, before
Iadjusting ,fence,
When you are not cutting at futlwidth of cut the fence can
be moved across the jointer/planer to take full advantage
ofthe "sharpness" of the blades.
When blades are new or freshly sharpened the fence
should be positioned to the extreme rear of outfeed and
infeed tables but not beyond the end of the b_ades.
Most of the cutting (usually jointing) will be done with the
fence in this position. /ks the blades become dull, the
fence can be moved toward the guard where the blades
are sharper,
To move the fence, turn jointer/planer off. iloosen Sliding
Fence Knob and slide the fence to the desired position,
SPECIAL NOTE: Make sure table extension is even or
above surface of Outfeed Table. If it is below the surface
see "Assembly' sectior_ under "Adjusting Table Extem
sion"
Fence Tilt 0 peration
a. Loosen Tilt Fence Knob.
b. Move fence to desired angle,
c. Tighten knob.
Tilt Knob
Maintenance and Lubrication
Maintenance
Do not allow pitch to accumulate on the tables, the
fence, the cutter guard, the cutterhead or the knives.
Clean them with Craftsman Gum and Pitch Remover.
Apply a thin coat of paste type wax to the tables and the
fence so that the wood slides easily while feeding. This
also deters resting.
Do not allow chips to accumulate on the underside of the
jointer/pfaner.
If power cord is worn, cut, or damaged in any way. have
it replaced immediately.
Disassembly ofthe motor should only be done by a qua!-
ified Sears Technician. Disregarding this may void your
tools warranty,
NOTE: The speed of this motor cannot be regulated or
changed.
Motors used on woodworking tools are particularly sus-
ceptible to the accumulation of sawdust and wood chips
and should be blown out or "vacuumed" frequently to pre-
vent interference with normal motor ventilation,
28
Loading ...
Loading ...
Loading ...