Loading ...
Loading ...
Loading ...
Seat
Battery
Door
_rminal
INSTALL SEAT
Adjust seat before tightening adjustment
knob.
• Remove adjustment knob and flat
washer securing seat to cardboard
packing and set aside for assembly of
seat to tractor.
• Pivot seat upward and remove from
the cardboard packing. Remove the
cardboard packing and discard.
• Place seat on seat pan and assemble
shoulder bolt. Tighten shoulder bolt
securely.
• Assemble adjustment knob and flat
washer loosely. Do not tighten.
• Lower seat into operating position and
sit onseat.
• Slide seat until a comfortable position
is reached which allows you to press
clutch/brake pedal all the way down.
* Get off seat without moving its adjusted
position.
• Raise seat and tighten adjustment
knob 'securely.
Seat
Shoulder Seat Pan
Bolt
Adjustment
Knob
NOTE: You may now roll or drive your
tractor off the skid. Follow the appropriate
instruction below to remove the tractor from
the skid.
TO ROLL TRACTOR OFF SKID (See
Operation section for location and
function of controls)
• Press lift lever plunger and"raise
attachment lift lever to its highest
position.
• Release parking brake by depressing
clutch/brake pedal.
* Place freewheel control in freewheel-
ing position to disengage transmission
(See =TO TRANSPORT" in the Opera-
tion section of this manual).
• Roll tractor forward off skid.
• Remove banding holding discharge
guard up against tractor.
TO DRIVE TRACTOR OFF SKID
AWARNING: Before starting, read,
understand and follow all instructionsin
the Operation section of this manual. Be
sure tractor is in a well-ventilated area.
Be sure the area in front of tractor Is
clear of other people and objects.
• Be sure all the above assembly steps
have been completed.
• Check engine oil level and fill fuel tank
with gasoline.
• Place freewheel control in "transmis-
sion engaged" position.
• Sit on seat in operating position,
depress clutch/brake pedal and set the
parking brake.
• Place motion control lever in neutral
(N) position.
• Press liftlever plunger and raise
attachment lift lever to its highest
position.
• Start the engine. After engine has
started, move throttle control to idle
position.
• Release parking brake.
• Slowly move the motion control lever
forward and slowly ddve tractor oft
skid.
• Apply brake to stop tractor, set parking
brake and place motion control lever in
neutral position.
•Tum ignitionkey to "OFF" position.
Continue with the instructions that follow.
8
Loading ...
Loading ...
Loading ...