Loading ...
Loading ...
Loading ...
TO ATTACH JUMPER CABLES -
• Connect each end of the RED cable to
the POSITIVE (+) terminal of each
battery, taking care not to short against
chassis.
• Connect one end of the BLACK cable
to the NEGATIVE (-) terminal of fully
charged battery.
• Connect the other end of the BLACK
cable to good CHASSIS GROUND,
away from fuel tank and battery.
TO REMOVE CABLES, REVERSE
ORDER -
• BLACK cable first from chassis and
then from the fully charged battery.
• RED cable last from both batterias.
PositiveTerminal Negative Terminal
Battery
PositiveTerminal
Negative Terminal
REPLACING BATTERY
A CAUTION: Do notshort battery
terminals by allowing a wrench Or any
other object to contact both terminals at
the same time. Before connecting battery,
remove metal bracelets, wristwatch
bands,rings,etc.
Positive terminal must be connected first
to prevent sparking from accidental
grounding.
* Lift seat pan to raised position and
open battery box door.
. Disconnect BLACK battery cable first
then RED battery cable and carefully
remove battery from tractor.
* Install new battery with terminals in
same position as old battery.
, First connect RED battery cable to
positive (+) terminal with hex bolt and
nut as shown. Tighten securely.
• Connect BLACK grounding cable to
negative (-) terminal with remaining
hex bolt and nut. Tighten securely.
• Close battery box door.
Seat
Nut Hex
(Red) Cable Black)
TO REPLACE HEADLIGHT BULB
• Raise hood.
• Pull bulb holder out of the hole in the
backside of the gdlL
• Replace bulb in holder and push bulb
holder securely back Into the hole in
the backside of the grill.
• Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause
your tractor to run poorly,stop running, or
prevent it from starting.
• Check wiring. See electrical wiring
diagram in the Repair Parts section.
TO REPLACE FUSE
Replace with 15 amp automotive-type
plug-in fuse. The fuse holder Is located
behind the dash.
TO REMOVE HOOD AND GRILL
ASSEMBLY
. Raise hood.
• Unsnap headlight wire connector.
• Stand in front of tractor. Grasp hood at
sides, tilttoward engine and lift off of
tractor.
* To replace, reverse above procedure.
_e_dli:ht Wire
25 _ector
Loading ...
Loading ...
Loading ...