Loading ...
Loading ...
Loading ...
• When the battery level has depleted below protection mode,
stop using the ALL-STAR 2.0 within 15 seconds.
• While sustaining a high discharge current during use (such as
driving up a steep slope for a long period of time), the ALL-STAR 2.0
will alert you, stop using the ALL-STAR 2.0 within 15 seconds.
CHARGING THE ALL-STAR 2.0
• Ensure that the charging port is clean and dry.
• Make sure that there is no dust, debris or dirt inside the port.
• Plug the charger into a grounded wall outlet. The charging
indicator light ON THE CHARGER will be green.
• Connect the cable with the power supply (100V ~ 240V; 50/60 Hz).
• Align and connect the 3-pin charging cable into the charging
port of the ALL-STAR 2.0. DO NOT FORCE THE CHARGER INTO THE
CHARGE PORT, AS THIS MAY CAUSE THE PRONGS TO BREAK OFF OR
PERMANENT DAMAGE TO THE CHARGE PORT.
• Once attached to the board, the charging indicator light ON THE
CHARGER should change to RED, indicating that your device is now
being charged.
• When the RED indicator light on your charger turns to GREEN, then
your ALL-STAR 2.0 is fully charged.
• A full charge may take up to 5 hours. While charging, you will see
a yellow flashing light on the scooter, which also indicates charging.
Do not charge for more than 7.5 hours.
•After fully charging your ALL-STAR 2.0, unplug the charger from
your ALL-STAR 2.0 and from the power outlet.
CHARGING YOUR ALL-STAR 2.0
WARNING
When the ALL-STAR 2.0 turns off during a Safety Alert,
all operation systems will halt. Do not continue
attempting to ride the ALL-STAR 2.0 when the system
initiates a stop. Turn your ALL-STAR 2.0 off and then
turn the board back on. And check calibration.
18
Loading ...
Loading ...
Loading ...